Abstract:Micro-fabrication techniques are developed rapidly because they offer numerous benefits for chemical and biological industries. Numerical simulations (based on incompressible Navier–Stokes equations) are presented of the two-phase flow in a cross-flowing T-junction micro-channel using the phase field method and the results are in agreement with experimental measurements. The leakage rate in the gap between the droplet and lower wall decreases during the droplet formation, the relationship between the leakage rate and the derivative of the up-stream droplet size is obtained, which is applicable when the droplet contacts with the lower wall on the wetted conditions or expands to the up-stream in the main channel. The droplet formation is related to several factors, including the capillary number, the contact angle, the flow rate ratio, and the micro-channel shape. The critical capillary number could distinguish between the squeezing and dripping regimes for the generation of different kinds of droplets. The simulations show that the critical capillary number is 0.012. Influence of those factors on the droplet length is related to the leakage rate. The leakage rate of the continuous phase decreases slowly as the flow rate ratio decreases or contact angle increases. In the squeezing regime, the leakage rate is weakly influenced by the contact angle at the small flow rate ratio and is different in three type micro-channels, the droplet length increases with the increase in contact angle which intensifies growth at the big flow rate ratio, and the longest droplet is obtained in the Y-junction micro-channel. In the dripping regime, at the big flow rate ratio the leakage rate is almost independent to the contact angle and micro-channel shape, and the droplet length also is same.

Generation of Droplets in the T-junction with a Constriction Microchannel

Dripping and Jetting Generation Mode in T-junction Microchannels with Contractive Structures

Droplet Generation at T-junctions in Parallelized Microchannels

Effects of Geometrical Confinement on the Generation of Droplets at Microfluidics T-junctions with Rectangle Channels

Droplet behavior and its effects on flow characteristics in T-junction microchannels

Uniformity and stability of droplet formation at T-junctions in symmetrical microchannels

Droplet Formation in a Microfluidic T-Junction Device

Experimental Study of Liquid–liquid Dispersion Patterns in T-inlet Microchannels with Different Junction Angles

Merged and Alternating Droplets Generation in Double T-junction Microchannels Using Symmetrically Inserted Capillaries

Numerical Simulation of Droplet Generation in Cross-Junction Microchannel under Changing Dispersion Phase Velocities

Generation of Micromonodispersed Droplets and Bubbles in the Capillary Embedded T‐junction Microfluidic Devices

Monodisperse Droplet Formation for Both Low and High Capillary Numbers in a T-junction Microdroplet Generator

Asymmetric branch selection and splitting of droplets in T-junction microchannels

Micro-Droplet Generation and Flow in a Microchannel under the Wall Fluctuation

Mixing Efficiency Analysis On Droplet Formation Process In Microchannels By Numerical Methods

Preparation of Highly Monodisperse Droplet in a T‐junction Microfluidic Device

Generation of Monodisperse Micro-Droplets Within the Stable Narrowing Jetting Regime: Effects of Viscosity and Interfacial Tension

Three-dimensional numerical simulation of a droplet generation in a double T-junction microchannel

Numerical Study On Liquid Droplet Formation In T-Junction Microchannel

Simulations of Droplet Formation in A T-Junction Micro-Channel Using the Phase Field Method

Droplet Motions Directed by an Expansion Section in the T-junctions