Sol–gel Preparation of Hierarchically Porous Magnesium Aluminate (mgal2o4) Spinel Monoliths for Dye Adsorption

Xingzhong Guo,Pengan Yin,Kazuyoshi Kanamori,Kazuki Nakanishi,Hui Yang
DOI: https://doi.org/10.1007/s10971-018-4781-0
2018-01-01
Journal of Sol-Gel Science and Technology
Abstract:Hierarchically porous spinel-type binary metal oxide MgAl2O4 with cocontinuous skeletons and interconnected macropores has been synthesized by a facile sol–gel method accompanied by phase separation, in which poly (ethylene oxide) (PEO) works as phase separation inducer to form micrometer-scale phase-separated macrochannels at the same time of sol–gel transition. The obtained xerogels exhibit in the form of a monolith with well-defined macropores and cocontinuous dense skeletons by adjusting the amount of PEO. The xerogel and those heat-treated at or below 600 °C are amorphous, and heat-treatment at or above 700 °C allows the precipitation of complete crystalline MgAl2O4 spinel with a macropore size of 0.7–0.9 μm, a porosity of 60–70%, and a BET surface area of 40–80 m2 g−1, without spoiling the macrostructure of monoliths. Three anionic dyes and two cationic dyes are selected as targeted adsorbates to investigate the selective adsorption ability of a hierarchically porous MgAl2O4 spinel. The resultant MgAl2O4 spinel shows a high affinity and adsorption rate toward anionic dyes Congo Red, Methyl Orange, and Methyl Blue. The maximum adsorption capacity of MgAl2O4 spinel toward these three anionic dyes are 2721.6 mg g−1 for Congo Red, 2469.7 mg g−1 for Methyl Orange, and 6771.9 mg g−1 for Methyl Blue, respectively.
What problem does this paper attempt to address?