Abstract:Alloy 2060, a new generation of aluminum–lithium (Al-Li) alloy, is widely used for aviation structural parts due to its high-specific strength and high-specific stiffness. However, poor formability of Al-Li alloy is commonly exhibited at room temperature. In this paper, the formability of Al-Li alloy 2060 was studied under the conditions of elevated temperatures. The Marciniak–Kuczynski (M–K) model was developed to effectively predict the forming limit curves (FLCs) under hot stamping conditions. Firstly, the hot tensile test was conducted to investigate the high-temperature deformation behaviors, and the Fields–Backofen equation was calibrated to represent the flow stress of the alloy. Then, the isothermal hemispherical punch tests were proposed to obtain the FLCs of Al-Li alloy 2060. Finally, the FLC predicted by the M–K model was input into the deep drawing finite element simulation model to verify the accuracy of the prediction results and predict the possible fracture of the hot stamping parts. The cup-shaped deep drawing test and the thin-walled shell part hot stamping test were carried out to verify the accuracy of the FLCs and the formability of the Al-Li alloy 2060. The results show that the true stress increases with the strain rate increasing and decreases with the temperature increasing. The established M–K model can accurately predict the FLCs of alloy 2060. It is also found that the initial thickness imperfection factor f0 is an important parameter that determines the change of FLC. Comparing the experimental and simulation results, it is concluded that the established M–K model would be adaptable in the FE simulation to estimate if the fracture of parts occurs. The simulation model considered the FLC can predict the fracture, thinning, and wrinkle of the parts. The stamping depth increases with the deformation temperature increasing and the blank holder force decreasing.

An Experimental and Numerical Investigation on the Formability of AA7075 Sheet in Hot Stamping Condition

Study on High-Temperature Mechanical Properties and Forming Limit Diagram of 7075 Aluminum Alloy Sheet in Hot Stamping

Hot deformation characteristics and processing maps of AA7075-H18 alloy sheet under hot forming process conditions

Experimental and Numerical Investigation on Strengthening Behavior of 7075 Aluminum Alloy Sheets in Hot Forming–Quenching Integrated Process

A Physical-Based Plane Stress Constitutive Model for High Strength AA7075 under Hot Forming Conditions

Damage and failure characterization of 7075 aluminum alloy hot stamping

Deep drawing of aluminum alloy 7075 using hot stamping

Effect of Heat Treatment Conditions on Mechanical Properties and Precipitates in Sheet Metal Hot Stamping of 7075 Aluminum Alloy

Modeling of constitutive behavior and ductile fracture of AA5A06 aluminum alloy sheet in warm hydroforming process

M–K model based forming limit prediction of aluminum–lithium alloy 2060 and its application in hot stamping

FEM model optimization study of mechanical properties and material selection in stamping process

Research on High Temperature Stamping Forming Performance and Process Parameters Optimization of 7075 Aluminum Alloy

Modeling the anisotropic plasticity and damage of AA7075 alloy in hot forming

Thermo-mechanical finite element analysis of the AA5086 alloy under warm forming conditions

Evaluation of the formability of AA2198-T3 Al-Li alloy in warm sheet hydroforming

Investigation on effect of high-efficiency solid solution and hot stamping process on microstructure evolution and mechanical properties of high-strength aluminum alloy

Fracture behavior of 7075-T6 aluminum alloy under electromagnetic forming and traditional stamping

Formability Evaluation of Aluminum Alloy 6061-T6 Sheet at Room and Elevated Temperatures

Hot Formability Study of Cr5 Alloy Steel by Integration of FEM and 3D Processing Maps

Experimental and Numerical Determination of Hot Forming Limit Curve of Advanced High-Strength Steel

Comparative study on deformation behavior, microstructure evolution and post-forming property of an Al Zn Mg Cu alloy in a novel warm forming process