Abstract:In this work, counter-gravity investment casting was used to fabricate TiAl parts with different cross-sections. A three-dimensional finite element model of counter-gravity investment casting was established based on ProCAST simulation software. The filling capacity and solidification behaviour during the counter-gravity investment casting of the Ti-48Al-2Cr-2Nb alloy were numerically investigated, and the effects of filling pressure, melt superheating temperature and mould preheating temperature were experimentally evaluated in terms of the filling integrity and casting defects. The results show that the filling pressure plays an important role in the filling capacity. Elevating properly the mould preheating and melt superheating temperatures can also improve the filling capacity. Then, counter-gravity investment casting was performed using the parameters optimised through numerical simulations, and sound Ti-48Al-2Cr-2Nb casting parts with different section sizes and shapes were produced. The as-cast microstructure of the Ti-48Al-2Cr-2Nb alloy indicates that the phase composition and morphology are largely affected by the size effect. Graphical abstract Counter-gravity investment casting was applied to fabricate TiAl parts. A FE model was established to calculate the filling capacity and solidification behaviour during the counter-gravity casting of the Ti-48Al-2Cr-2Nb alloy. The effects of filling pressure, melt superheating and mould temperature were evaluated. Based on the numerical results, sound Ti-48Al-2Cr-2Nb casting parts with different section sizes and shapes were produced with an optimised processing window. The as-cast microstructure of the Ti-48Al-2Cr-2Nb alloy indicates that the phase composition and morphology are largely affected by the size effect.

Numerical calculation and experimental evaluation of counter-gravity investment casting of Ti-48Al-2Cr-2Nb alloy

Numerical Modeling and Experiment of Counter-Gravity Casting for Titanium Alloys

Numerical simulation of counter gravity casting of TiAl blades

A Combined Electromagnetic Levitation Melting, Counter-Gravity Casting, and Mold Preheating Furnace for Producing TiAl Alloy

The Current Status and Prospect of Computer Numerical Simulation of Investment Casting for TiAl Alloy

Numerical Simulation of Process of Cavity Filling and Solidifying in Tial Alloy Investment Casting

Numerical Simulation of Filling and Solidification of Large Complex ZTC4 Alloy Castings

Numerical Simulation and Analysis on Casting Process of TiAl Alloy

Modeling Of Tial Alloy Grating By Investment Casting

Effect of Mold Temperature and Casting Dimension on Microstructure and Tensile Properties of Counter-Gravity Casting Ti-6Al-4V Alloys

Influence of pouring temperature and mold preheating temperature on investment casting of TiAI

Prediction and Improvement of Shrinkage Porosity in Tial Based Alloy

Numerical Simulation for the Investment Casting Process of a Large-Size Titanium Alloy Thin-Wall Casing

Numerical Simulation of Microstructure Evolution During the Solid Phase Transformation of Ti-6al-4v Alloy in Investment Casting

Counter-Gravity Casting Equipment and Technologies for Thin-Walled Al-Alloy Parts in Resin Sand Molds

Fabrication and Microstructure Optimization of TiAl Castings Using a Combined Melting/Pouring/Heat Treatment Device

Numerical Simulation of Microstructure Evolution of Ti-6al-4v Alloy in Vertical Centrifugal Casting

Modeling of Investment Casting of Ti48Al48Cr2Nb2 (at%) Alloy Air Rudder Skeleton

Progress of the Counter Gravity Casting Technology in the Superalloy Large Complicated Thin-Walled Castings

Numerical Simulation and Process Optimization of Vacuum Investment Casting for Be–Al Alloys

Interactions Between TiAl and ZrO2 Face Coat During Centrifugal Investment Casting