Abstract:An accurate constitutive model lays an analytical foundation for the thin-walled tube plastic joining process. This study obtained the best-fitted constitutive model to accurately simulate the steel/aluminum thin-walled tubes cracking during plastic joining. The process of establishing the constitutive model comprises three parts: 1) The flow stress model of AA6061 was determined by comparing the fit of seven flow stress models and experiments, and the model parameters were calibrated using a genetic algorithm. 2) A method combined with experiment and simulation was adopted to obtain the failure parameters in the ductile fracture criterion. 3) Combinations of different ductile fracture criteria and yield criteria were implemented into the VUMAT subroutine to simulate uniaxial tension. The constitutive model of AA6061 was determined based on the comparison of simulation and experiment. Subsequently, the constitutive model was applied to the cracking prediction of the steel/aluminum thin-walled tube plastic joining process. The predicted cracking was compared with the experimental cracking. Finally, the cracking risk areas were evaluated by the forming limit diagram. The results indicated that the Voce-Swift model could better reflect the trend of AA6061 flow stress and the genetic algorithm could effectively improve the Voce-Swift model fitting accuracy. The uniaxial tensile simulation suggested that the Cockcroft-Latham criterion combined with the Hill48 anisotropic criterion could accurately predict the fracture of AA6061. Moreover, the steel/aluminum joint simulation cracking matched very well with the experiment, which verified the validity of the constitutive model in predicting cracking during the plastic joining process. Finally, the aluminum/aluminum joint simulation result proved that the risk of cracking in the upper tube was more significant than in the lower tube. The AA6061 tube with poor plasticity should be the lower tube to improve the formability of the steel/aluminum joint.

Formability Assessment of Plastic Joining by Compression Instability for Thin-Walled Tubes

Modeling and Simulation of Tubular Form-Fit Joint Forming by Internal Rolling

Whole Process Modeling of Joining of Flareless AA 6061-T4 Tube by Extrusion-Bulging Forming Using a Polyurethane Elastomer Medium

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Further Assessment of the Plastic Instability of Thin-Walled Tubes in Double-Sided Hydro-Bulging Process with Verification Experiments

Practicality and Formability of Integrally Stiffened Tube Hydro-Assisted Forming

Effect of Geometric Parameters on Folding of Thin-Walled Steel Tube under Axial Compression

INSTABILITY ANALYSIS AND EXPERIMENT STUDY ON TUBE HYDRO-FORMING

Research on multi-steps tube-compression of thin-wall parts with variable diameter by viscous pressure forming

Evaluation of Formability and Material Characteristics of Aluminum Alloy Friction Stir Welded Tube Produced by a Novel Process

Plastic deformation regularity of tailor-welded tube hydroforming

Effect of Wrinkling Behavior on Formability and Thickness Distribution in Tube Hydroforming

Analysis of Plastic Wrinkling Behavior in Tube Hydroforming Process

An investigation into the plastic formability of welded joints

Failure Mechanism and Forming Limit of Tube Axial Compressive Process

Forming Characteristics of Thin-Walled Tube Bending Process with Small Bending Radius

Plastic Deformation Analysis of Thin-walled Tube Bending under Internal Pressure

A Constitutive Model for Cracking Prediction of Steel/aluminum Thin-Walled Tubes During Plastic Joining

Tube/Tube Joining Technology by Using Rotary Swaging Forming Method

Mechanical Conditions of Stiffened Tube during Hydro-assisted Forming