Abstract:Wrinkling in unsupported region is a worthy problem to be solved in sheet metal forming process. Sheet hydroforming is advantageous in the prevention of unsupported wrinkles. However, the simply increasing of liquid pressure is not enough to suppress the wrinkling even though with the occurrence of “reverse bulging effect” .11Normally, the unsupported areas of sheet metals during hydroforming are easy to be bulged along the reverse direction of deep drawing, this phenomenon can be regarded as a “reverse bulging effect”. In order to predict and control the wrinkling quantitatively in unsupported region for thin-walled shells with curved surface, a theoretical model on critical wrinkling stress was proposed by considering proper “reverse bulging effect” based on energy method. The influence of liquid pressure and other parameters on the critical wrinkling stress was analyzed. The critical loading path of the liquid pressure to control wrinkling was obtained by combining critical wrinkling stresses and circumferential stresses. An experimental setup for an extremely thin-walled shell with semi-ellipsoidal geometry was designed and manufactured to verify the theoretical model. It is found that at a certain punch stroke, the magnitude of the critical wrinkling stress increases and that of circumferential compressive stress decreases with the improvement of the liquid pressure. The critical loading path can be utilized to get well formed shells with a ratio of thickness to diameter equals 0.27% in the experiments. The proposed method can be applied to predict and control wrinkling in unsupported region for hydroforming of thin-walled shell with high accuracy and considerably reduced simulation time.

The Effect of Upper Sheet on Wrinkling and Thickness Distribution of Formed Sheet Part Using Double-Layer Sheet Hydroforming

Wrinkle Behavior of Hydroforming of Aluminum Alloy Double-Layer Sheets

Research on the selection principle of upper sheet in double-layer sheets hydroforming

Effect of Wrinkles on Formability in Hydroforming A Double-Diameter Aluminum Alloy Tubular Part

Study on hydroforming of AA6061-T6 aluminum alloy sheet based on upper sheet

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Mechanism Analysis on Thickness Distribution of Aluminum Alloy Hemispherical Shells in Double-Sided Sheet Hydroforming

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Effect of Wrinkling Behavior on Formability and Thickness Distribution in Tube Hydroforming

Research Development on Wrinkling Prediction and Suppression for Sheet Hydroforming of Thin-walled Deep Drawing Parts

Analysis and experiment on wrinkling suppression for hydroforming of curved surface shell

Hydro-forming of Aluminum Alloy Complex-Shaped Components

Experimental and Numerical Investigation into Useful Wrinkling During Aluminium Alloy Internal High-Pressure Forming

Formability Influenced by Process Loading Path of Double Sheet Hydroforming

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

Investigation into the Innovative Sheet Hydroforming and the Effect of Key Process Parameters

Research on wrinkling behavior in tube hydroforming

Analysis of wrinkling during sheet hydroforming of curved surface shell considering reverse bulging effect

Investigation into the Pre-Forming'S Effect During Multi-Stages of Tube Hydroforming of Aluminum Alloy Tube by Using Useful Wrinkles

Numerical and Experimental Study on Sheet Hydroforming of 2A12 Aluminum Alloy