Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Deformation Behavior of Saddle Surface Part During Multi-Point Forming under Normally Full Constraint Condition

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Deformation Behavior of Curved Shells in Multi-Point Forming with Asymmetric Punches

Shape Accuracy Analysis of Multi-Point Forming Process for Sheet Metal under Normal Full Constrained Conditions

Deformation characteristics and forming force limits of multi-point forming with individually controlled force–displacement

Understanding a New Wrinkling Behavior of Annular Grooved Panel During Flexible Free Incremental Sheet Forming

Formability limits by wrinkling in sheet metal forming

Comparing between multi-point forming and stamping processes for sheet metal parts

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Sheet metal forming limits under stretch-bending with anisotropic hardening

Multi-point forming technology for sheet metal

Forming Limits of a Sheet Metal after Continuous-Bending-Under-Tension Loading

Analytical and Experimental Investigations on Deformation Mechanism and Fracture Behavior in Single Point Incremental Forming

Study on the mechanism of wrinkle flattening under internal pressure and the critical condition of dead wrinkle

Construction of 3D sheet forming limit diagrams considering through-thickness normal pressure

The mechanics of multi-point sandwich forming

Numerical Investigations on the Influence of Superimposed Double-Sided Pressure on the Formability of Biaxially Stretched Aa6111-T4 Sheet Metal

Evaluation and simulation on deformation instability mechanism in laminated sheet incremental forming

Numerical Simulation of Deformation in Multi-Point Sandwich Forming

Research on Discrete Clamp Motion Path Control-Based Stretch-Forming Method for Large Surfaces