Abstract:Deep drawing is the most advanced sheet metal forming technique. In today’s demanding environment is the global environment and energy saving, the process has been supposed to play a vital role in light-weight component industry. Light-weight, high strength, low density and extreme corrosion aspects must be almost guaranteed in a deep drawn product. However, due to those requirements, thinning and wrinkling and other defects will be increased also. Numerous elements such as blank-holder pressure, punch force, speed of punch, blank shape, thickness variation, surface-to-surface friction coefficient, material characteristic,...influenced to the success of methods as well as the quality of the products. In addition, worldwide manufacturers keep getting the most goods done in less time. Indeed, the increasing of productivity should be also dealt because it proportionally relates to the stamping speed. This paper investigates the influence of punch velocity on deformation behavior of aluminum alloy 5052–H112. Finite Element Method was used to perform Nakajima test at several of punch velocities of specimen widths and monitor fluctuations in magnitude of von Mises stress, the major strain and minor strain. Forming Limit Curve (FLC) was obtained at different velocities and almost uniform. Stretching and sliding across the top of the punch resulted in thinning of sheet metal. Beside this, the action of punch stroke resulted in the production of more von Mises concentrated stress and the largest specimen in widths had shown the peak value of von Mises stress compared with the other specimens at all different velocities. Furthermore, the ratio of the major strain to the minor strain is influenced by the mass of material at the contact area and keeps consistent over the variation in velocities of punch. This will pave the way for future studies of the optimization of the stamping speed in deep drawing.

Comparing between multi-point forming and stamping processes for sheet metal parts

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Multi-point forming technology for sheet metal

FEM model optimization study of mechanical properties and material selection in stamping process

Numerical Simulation of Microstamping Process to Fabricate Multi-channel of SUS304 Thin Sheets with Consideration of Grain Structures

Numerical Simulation and Experiment of Microstamping Process to Fabricate Multi-Channel of SUS304 Thin Sheets with Different Grain Size

Research on Sheet Metal Digital Incremental Forming Technology without Support

Effect of multi-point roller dies on the forming accuracy of profile in flexible 3D stretch bending technology

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

The study on the relationship between the friction characteristic and the formability of the automotive steel sheet during the stamping process

Effect of discrete roller dies on the contour accuracy of profiles in multi-point flexible stretch-bending forming

Forming Defects Analysis of Auto-Panel Stamped Part with Experimental Strain Approach

Stamping Process Optimization for the Rear Part of Door Inner Pane(lContinued 1)

Analysis of Sheet Metal Forming (Stamping Process): A Study of the Variable Friction Coefficient on 5052 Aluminum Alloy

Formability limits by wrinkling in sheet metal forming

Analysis of the Stamping Speed for Sheet Metal Forming of Aluminum Alloy 5052-H112

Research on the Micro Sheet Stamping Process Using Plasticine as Soft Punch

Forming Process and Morphology Control of Mechanical Clinch Joint of Steel/Aluminum Sheet

Study on deformation difference between the contact zone and the non-contact zone of the flexible 3D stretch bending profile and roller dies based on pre-stretching amount

Finite Element Analysis and Design in Stainless Steel Sheet Forming and Its Experimental Comparison

Research on the Mechanism and Processability of Roll Forming