Alveolar Bone Stress Around Implants With Different Abutment Angulation: An FE-Analysis of Anterior Maxilla
A. Monzavi,P. Sadr-eshkevari,R. Sadrimanesh,P. Maurer,A. Rashad,H. Siadat
DOI: https://doi.org/10.1097/ID.0b013e31824c302e
2012-06-01
Implant Dentistry
Abstract:Objectives:To comparatively assess the masticatory stress distribution in bone around implants placed in the anterior maxilla with three different labial inclinations. Materials and Methods:Three-dimensional finite element models were fabricated for three situations in anterior maxilla: (1) a fixture in contact with buccal cortical plate restored by straight abutment, (2) a fixture inclined at 15 degrees, and (3) 20 degrees labially restored with corresponding angled abutment. A palatal bite force of 146 N was applied to a point 3 mm below the incisal edge. Stress distribution around the bone-fixture interface was determined using ANSYS software. Results:The maximum compressive stress, concentrated in the labial crestal cortical bone, was measured to be 62, 108, and 122 MPa for 0-, 15-, and 20-degree labially inclined fixtures, respectively. The maximum tensile stress, concentrated in the palatal crestal cortical bone, was measured to be 60, 108, and 120 MPa for 0-, 15-, and 20-degree labially inclined fixtures, respectively. Conclusions:While all compressive stress values were under the cortical yield strength of 169 MPa, tensile stress values partially surpassed the yield strength (104 MPa) especially when a 20-degree inclination was followed for fixture placement.
Medicine,Materials Science,Engineering