Abstract:In this work, we propose a simple and efficient interfacial modification method for thin-film transistor (TFT)-1 with poor stability under bias stress. For conventional top-contact TFT-2, the sputtering passivation layer will cause the device to be in a short-circuit condition. We used inverted coplanar-structured TFT-3 to separate the high conductivity layer from the S/D electrodes to avoid the short-circuit failure of the device, but this will cause a hump effect. Ultraviolet treatment and air annealing were performed on TFT-3 simultaneously to obtain TFT-4 with high mobility (μsat = 45.5 cm2 V–1 s–1), steep subthreshold swing (SS = 86 mV/dec), and good bias stability (±20 V, 3600 s, NBS: −0.1 V, PBS: +0.9 V, PGDBS: +0.5 V). The forward and reverse tests of TFT-1 and TFT-4 after the PGDBS test show that TFT-4 has a good stability of the asymmetric electrical bias. Finally, XRR, XPS, AFM, and contact angle were tested to further investigate the material mechanisms. In this paper, we show that the interfacial passivation of TFT can effectively isolate the invasion of external water/oxygen and compensate for interfacial defects and dangling bonds. The decomposition and rearrangement of the oxide are induced by UV + thermal annealing, which optimizes the stacking pattern of the cells, effectively reducing the defect states and eliminating parasitic channels and the hump phenomenon. Finally, an amorphous oxide semiconductor (AOS)-TFT instrument with high mobility and good stability is prepared. The method in this paper addresses the problem that the passivation layer cannot be prepared by sputtering, which is a cost-effective process.

Effects Of Interfacial Passivation On The Electrical Performance, Stability, And Contact Properties Of Solution Process Based Zno Thin Film Transistors

Solution-Processed Zinc Oxide Thin-Film Transistors with a Low-Temperature Polymer Passivation Layer

Influence of passivation deposition on the performance of In-Zn-O thin-film transistors based on etch-stopper structure

Solution-Processed Indium-Zinc-Oxide Thin-Film Transistors Based On Anodized Aluminum Oxide Gate Insulator Modified With Zirconium Oxide

Enhanced Performance of ZnO Thin-Film Transistors with ZnO Dual-Active-layer

Fabrication of Zinc Oxide Thin Film Transistors via Low-Temperature Solution Processing

Effect of Source/drain Preparation on the Performance of Oxide Thin-Film Transistors

Effective encapsulation of ZnO thin film transistors controlled by thermal energy

Low-Voltage High-Stability InZnO Thin-Film Transistor Using Ultra-Thin Solution-Processed ZrO Dielectric

Improvements in passivation effect of amorphous InGaZnO thin film transistors

Feasibility of Atomic Layer Deposited AlZrOx Film to Achieve High Performance and Good Stability of ZnSnO-TFT

Effect of Sc2O3 Passivation Layer on the Electrical Characteristics and Stability of InSnZnO Thin-Film Transistors

Stability Enhancement of Low Temperature Thin-Film Transistors with Atomic-Layer-Deposited Zno:Al Channels

Enhancement of electrical properties of solution-processed oxide thin film transistors using ZrO<sub>2</sub> gate dielectrics deposited by an oxygen-doped solution

Low-voltage, Solution-Processed InZnO Thin-Film Transistors with Enhanced Performance Achieved by Bilayer Gate Dielectrics

Fabrication of High-Performance Solution Processed Thin Film Transistors by Introducing a Buffer Layer

The Hump Phenomenon and Instability of Oxide TFT Were Eliminated by Interfacial Passivation and UV + Thermal Annealing Treatment

Effect of Sc 2 O 3 Passivation Layer on the Electrical Characteristics and Stability of InSnZnO Thin-Film Transistors

Enhanced Electrical and Mechanical Performance of InSnZnO TFTs With Multifunctional Laminated Organic Passivation Layer

Teflon/SiO2 Bilayer Passivation for Improving the Electrical Reliability of Oxide TFTs Fabricated Using a New Two-Photomask Self-Alignment Process

The Effects of High Work Function Electrodes on the Electrical Properties of Solution Processed ZnO Thin Film Transistor