Abstract:Wide frequency coverage phase locked loops (PLL) with fine frequency resolution and low phase noise are one of the most critical building blocks for the high speed communication systems. Voltage domain quantization scheme employing ADCs has been proposed in previous fractional-N PLLs as an alternative to DTC-based quantization cancellation. However, though the voltage-domain quantization is linear in modern processes, the potential nonlinearity in the time-to-voltage conversion preceding the ADC results in fractional spurs and noise folding, which will severely degrade the PLL output if not properly addressed. One approach applies linearity compensation that often requires sophisticated digital processing [1]–[2]. The other approach utilizes digital-to-time converters (DTC) or digital-to-analog converters (DAC) to generate a replica of the divider quantization noise and then cancels out this noise in the analog domain before it propagates into the loop [3]–[4], thus relaxing the requirement for linear phase detection range. Prior arts have achieved remarkable phase noise performances, at the cost of significantly higher design complexity. This work describes a wideband fractional-N PLL that uses an integrator-based time-to-voltage converter and a 10-bit SAR ADC for direct phase error digitization as shown in Fig. 1. Without linearity calibration or DTC/DAC-based quantization noise cancellation, the proposed PLL achieves low fractional spur and low jitter across a wide frequency range.

A Digital Phase Noise Cancelling Scheme for Ring Oscillator-based Fractional-N ADPLL

A Low-Phase-Noise UHF-Band Fractional-N Frequency Synthesizer

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

A 4 to 5ghz Digitally Controlled Ring Oscillator with 100khz Resolution Using Noise Cancellation Technology in 40nm CMOS.

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A Low In-Band Phase Noise Fractional-N ADPLL Based on Switched-Capacitor-DPI

A Calibration-Free Fractional-N ADPLL Using Retiming Architecture and a 9-Bit 0.3Ps-Inl Phase Interpolator.

A Sub-mW Fractional-<inline-formula> &Lt;tex-Math Notation="latex">${n}$ &Lt;/tex-Math> &Lt;/inline-Formula> ADPLL with FOM of −246 Db for IoT Applications

An FIR-Embedded Noise Filtering Method for $\delta \sigma$ Fractional-N PLL Clock Generators

A multi-phase detecting method for spurs cancellation in all digital fractional-N phase-lock loops

A Latency-Proof Quantization Noise Reduction Method for Digitally-Controlled Ring Oscillators

A High-Psrr ADPLL with Self-Regulated GRO TDC and DCO-dedicated Voltage Regulator

A fractional-NBB-DPLL with auto-tuned DTC and FIR filter for noise and spur reduction

A Fractional- $N$ Sampling PLL with a Merged Constant-Slope DTC and Sampling PD

A Calibration-Free 800 MHz Fractional-N Digital PLL With Embedded TDC

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

Fractional- N PLL with multi-element fractional divider for noise reduction