Abstract:This paper presents advancements in the performance of digital phase-locked loop (DPLL)s, with a special focus on addressing the issue of required gain calibration in the time-to-digital converter (TDC) within phase-domain DPLL structures. Phase-domain DPLLs are preferred for their simplicity in implementation and for eliminating the delta–sigma modulator (DSM) noise inherent in conventional fractional-N designs. However, this advantage is countered by the critical need to calibrate the gain of the TDC. The previously proposed dual-interpolated TDC(DI-TDC) was proposed as a solution to this problem, but strong spurs were still generated due to the TDC resolution, which easily became non-uniform due to PVT variation, degrading performance. To overcome these problems, this work proposes a DPLL with a new calibration system that ensures consistent TDC resolution matching the period of the digitally controlled oscillator (DCO) and operating in both the foreground and background, thereby maintaining consistent performance despite PVT variations. This study proposes a DPLL using a calibrated dual-interpolated TDC that effectively compensates for PVT variations and improves the stability and performance of the DPLL. The PLL was fabricated in a 28-nm CMOS process with an active area of only 0.019 mm2, achieving an integrated phase noise (IPN) performance of −17.5 dBc, integrated from 10 kHz to 10 MHz at a PLL output of 570 MHz and −20.5 dBc at 1.1 GHz. This PLL operates within an output frequency range of 475 MHz to 1.1 GHz. Under typical operating conditions, it consumes only 930 μW with a 1.0 V supply.

A High-Psrr ADPLL with Self-Regulated GRO TDC and DCO-dedicated Voltage Regulator

A PSRR Enhancing Method for GRO TDC Based Clock Generation Systems

An All‐digital Phase‐locked‐loop with a Robustness Enhanced Dual‐mode DCO

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

A 0.55V 100mhz ADPLL with ΔΣ LDO and Relaxation DCO in 65nm CMOS

A 5.4 GHZ All-Digital Phase-Locked Loop with a wide output swing and high-linearity DAC

A 2.5ghz Adpll With Pvt-Insensitive Delta Sigma Dithered Time-To-Digital Conversion By Utilizing An Addll

A 4 to 5ghz Digitally Controlled Ring Oscillator with 100khz Resolution Using Noise Cancellation Technology in 40nm CMOS.

A 7.2G-16Ghz ADPLL Based on a Single-Core Dual-Mode DCO

All‐digital PLL with ΔΣ DLL Embedded TDC

A Digital Phase Noise Cancelling Scheme for Ring Oscillator-based Fractional-N ADPLL

A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A Dual-Path Subsampling PLL With Ring VCO Phase Noise Suppression

A 14ghz Cascade Differential-Capacitor-Based DCO with Resistor-Biased Buffer.

A PVT tolerant 10 to 500 MHz all-digital phase-locked loop with coupled TDC and DCO

15.1 A 0.0066mm2 780μw Fully Synthesizable PLL with a Current-Output DAC and an Interpolative Phase-Coupled Oscillator Using Edge-Injection Technique

A CMOS digital-controlled oscillator for All-digital PLL frequency synthesizer

A Fully Synthesizable Fractional-N Digital Phase-Locked Loop with a Calibrated Dual-Referenced Interpolating Time-to-Digital Converter to Compensate for Process–Voltage–Temperature Variations

A 0.0055mm2 480µw Fully Synthesizable PLL Using Stochastic TDC in 28nm FDSOI

A PVT-insensitive Self-Dithered TDC Design by Utilizing a ΔΣ DLL