Abstract:In micro-electrical discharge machining (micro-EDM) milling, the cross-section of the microgroove machine is frequently not an ideal rectangle. For instance, there are arc shapes on the bottom and corners, and the sidewall is not steep. The theoretical explanation for this phenomenon is still lacking. In addition to the tip discharge effect, the essential reason is that there is an accumulative difference in time and space during the shape change process of a tool electrode and the microstructure formation on a workpiece. The process parameters are critical influencing factors that determine this accumulative difference. Therefore, the accumulative difference mechanism in time and space is investigated in this paper, and then a theoretical model is developed to simulate the micro-EDM milling process with a straight-line single path. The simulation results for a cylindrical electrode at the two rotational speeds of 0 (nonrotating) and 300 rpm are compared, while the results for a cylindrical electrode and a square electrode at a rotation speed of 0 are also compared to verify that different process parameters generate accumulative differences in the time and space of material removal. Finally, micro-EDM milling experiments are carried out to verify the simulation model. The maximum mean relative deviation between the microgroove profiles of simulation results and those of experiments is 11.09%, and the profile shapes of simulations and experiments have a good consistency. A comparative experiment between a cylindrical electrode and a hollow electrode is also performed, which further verifies the mechanism revealed in the study. Furthermore, the cross-section profile of a microgroove can be effectively controlled by adjusting the process parameters when utilising these accumulative differences through fabricating a microgroove with a V-shaped cross-section by a square electrode and a microgroove with a semi-circular cross-section by a cylindrical electrode. This research provides theoretical guidance for solving the problems of the machining accuracy of detail features in micro-EDM milling, for instance, to machine a microgroove with an ideal rectangular cross-section.

Investigations on Material Removal Rate and Surface Roughness of Meso Gear by Micro Wire-Edm.

Investigation on MRR and Machining Gap of Micro Reciprocated Wire-EDM for SKD11

Improvement of the Machining Characteristics in WEDM Based on Specific Discharge Energy and Magnetic Field–assisted Method

Optimizing Wire Electrical Discharge Machining Parameters for Enhanced Gear Machining Performance: A Machine Learning Approach on 20MnCr5 Steel

Investigation of Machining Rate and Surface Roughness in Wire EDM of Al6063/WC/ZrO2 Composite using Response Surface Methodology

Optimization of the Material Removal Rate and Electrode Wear Ratio in Electrical Discharge Machining of Reaction-bonded Silicon Carbide by Response Surface Methodology

Experimental investigation on the surface quality of WEDM machined 20MnCr5 steel for Gear application

Investigation of aluminum alloy 6061 in Wire-EDM regarding surface roughness and material removal rate by adopting optimization techniques

Experimental investigations and process optimization of SKD61 for sinking EDM

Optimization of EDM Machining of High Carbon High Chromium Steel Using Zirconium and Nickel Powder Mixed Dielectric by Grey Relational Analysis

Investigation of magnetic field effect on MRR, EWR and surface roughness during EDM of AISI420 tool Steel

Experimental Investigation and Optimization of Wire Electrical Discharge Machining for Surface Characteristics and Corrosion Rate of Biodegradable Mg Alloy

Research on Electronic Discharge Grinding of Polycrystalline Diamond Based on Response Surface Method

An Investigation into Accumulative Difference Mechanism in Time and Space for Material Removal in Micro-EDM Milling

Influence of Machining Parameters on Surface Roughness in Finish Cut of WEDM

Experimental study of MWEDM technology

Parametric effect on material removal rate and surface roughness of electrical discharge machined magnesium alloy

Researches on the EDM of magnetized sintered NdFeB permanent magnetic material

Die-sinking EDM of Al6061-T6: interactions between process parameters, process performance, and surface characteristics

Micro Reciprocated Wire-Edm of Micro-Rotating Structure Combined Multi-Cutting Strategy

Modeling and experiment of material removal rate for cutting single-crystal silicon by electrical discharge wire sawing