Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Bending modes and transition criteria for a flexible fiber in viscous flows

Bending Modes And Transition Criteria For A Flexible Fiber In Viscous

Smoothed Particle Hydrodynamics and Element Bending Group Modeling of Flexible Fibers Interacting with Viscous Fluids.

Particle-Based Modeling of Asymmetric Flexible Fibers in Viscous Flows

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Rheological Properties of Fiber Suspensions Flowing Through a Curved Expansion Duct

Electricity-structure-fluid Coupled Modelling and Experiment of Underwater Flexible Structure with Partially Distributed Macro Fiber Composites

Dynamics of flexible fibers in confined shear flows at finite Reynolds numbers

A Viscoelastic Model for Flexible Fibers with Material Damping

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Orientation Distribution and Rheological Properties of Fiber Suspensions Flowing Through Curved Expansion and Rotating Ducts

A Bonded Sphero-Cylinder Model for the Discrete Element Simulation of Elasto-Plastic Fibers

Numerical simulation on velocities of two interacting fibers in fiber suspension

Simulation of fiber suspension flowing through a stock pump impeller with two-way coupling

Flexible fibers in shear flow approach attracting periodic solutions

Deformation of a flexible fiber in a viscous flow past an obstacle

Fiber Orientation Distributions in Slit Channel Flows with Abrupt Expansion for Fiber Suspensions

A numerical simulation of VIV on a flexible circular cylinder

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

Dynamics of flexible fibers in viscous flows and fluids

RESEARCH ON THE SPECIFIC VISCOSITY OF SEMI-CONCENTRATED FIBER SUSPENSIONS