Abstract:Eddy current testing (ECT) is one of the most important techniques in nondestructive evaluation. A higher probe sensitivity is always pursued in ECT. To improve the probe sensitivity, the near electrical resonance signal enhancement (NERSE) technique was recently proposed. In the NERSE technique, a coaxial cable connecting with the probe coil is introduced to provide a capacitance for the electrical resonance. However, the long coaxial cable is awkward and inconvenient in engineering applications, restraining the usability of such probes. Metamaterials (MTMs) are novel artificial electromagnetic media and have been proved to be effective in manipulating the impedance of a solenoid coil. In other words, in principle, MTMs can be used in the same way as that a coaxial cable in NERSE in ECT. Based on this argument, low-frequency magnetic MTMs are introduced as the probe cores to provide a new approach to achieve the electrical resonance for the NERSE technique. A promising feature of the proposed approach is that the detecting signals and sensitivity are significantly increased due to the extraordinary electromagnetic properties of the MTM. The most salient features of an MTM core over a ferrite core are: 1) effective permeability of the MTM core will vary sharply from a high positive to a high negative values when crossing the resonance frequency, resulting in not only a high magnetic flux density in the tested material but also an extremely large variation of the normalized impedance which is very essential in identifying a crack and 2) electromagnetic properties of an MTM will increase with the increase of frequency, whereas those of a ferrite material usually degrade sharply with the increase of frequency. To demonstrate the advantages of the proposed new probe, comprehensive numerical and experimental studies are conducted, and the results have shown the high performance of the proposed probe. In addition, the proposed MTM-core probe also exhibits a diverse versatility and convenience in engineering applications as compared with the existing NERSE technique.

Study on Metal Tag Identification Impedance Characteristics Based on Eddy Testing

GMR effect based crack ECT for nonferromagnetic metal material

An investigation for the design of the metal barcode label with patterns read by the eddy current testing

An Analysis in Metal Barcode Label Design for Reference.

A Sub-Optimum Reception of the Metal Barcode Label Read by Eddy Current Testing

Mechanism of Magnetic Permeability Perturbation in Magnetizing-Based Eddy Current Nondestructive Testing

Quantitative NDE of Cellular Metallic Materials and Structures by Using Eddy Current Testing Technique

Metamaterial-Core Probes for Nondestructive Eddy Current Testing.

Passive UHF RFID Tag As a Sensor for Crack Depths

Linear Characteristics of the Differences in Phase Tangents of Triple-Coil Electromagnetic Sensors and their Application in Nonmagnetic Metal Classification

Study of Signal Mechanism Based on Combining Magnetic Flux Leakage and Eddy Current Testing

Advancing eddy current detection probes with magnetoelectric composite Materials: Enhancing crack detection in conductive materials

Comparison on Pipeline Welds and Integrity Through Different Electromagnetic NDT Techniques.

The Fast Calculation of the Metal Barcode Label Read by the Eddy Current Testing with the Dyadic Green Function Method

Mechanism of Defect Detections for Rectangular Differential Probes of Pulsed Eddy Current Testing

An analysis for the inter bit interference in reading a metal barcode label

Study of metal magnetic memory (MMM) technique using permanently installed magnetic sensor arrays

Research on the visual detection technology using eddy current microscope

Magnetic Field-Based Eddy-Current Probe Design, Modeling, and Computing Methods for Edge Defect Detection

A Method Using Magnetic Eddy Current Testing for Distinguishing ID and OD Defects of Pipelines under Saturation Magnetization

A Study of Electromagnetic Acoustic Emission Technology in Non-destructive Testing