Abstract:Metal detectors are extensively used to find undesirable metal objects in processed food. In such a typical metal detector, the coils are coaxially arranged with the transmitting coil in the center and two receiving coils on the sides. The receiving coils are connected to a differential amplifier. When the magnetic field generated in the transmitting coil is disturbed by metal objects, the amplitude and phase of the output voltage of the differential amplifier change, and, thus, the existence of foreign metal pieces is detected. The relationship between the amplitude and phase of the output and the electromagnetic properties of the metal objects, however, has only been discussed experimentally so far. The authors have already developed the SRPM method to simultaneously estimate the electrical and magnetic properties of a spherical sample by vectorially measuring the difference in the impedance of two circular solenoid coils, one with and the other without a sample. An attempt is made to theoretically analyze the properties, such as size, conductivity, and permeability of the metal objects from the output, i.e., amplitude and phase of the metal detector. Based on this method, an equation to estimate the vector voltage induced in the receiving coil by the metal object is derived by using a spherical sample to simplify the analysis. The validity of the new formula was confirmed by experiments using brass, aluminum, copper, and iron objects. The new formula proposed in this paper is expected to be an important guide in designing a metal detector, which in the past depended on the experimental analytical method.

An Analysis in Metal Barcode Label Design for Reference.

Study on Metal Tag Identification Impedance Characteristics Based on Eddy Testing

An analysis for the inter bit interference in reading a metal barcode label

An investigation for the design of the metal barcode label with patterns read by the eddy current testing

An analysis of the correlation reception applied in reading a metal barcode label

A Sub-Optimum Reception of the Metal Barcode Label Read by Eddy Current Testing

The Fast Calculation of the Metal Barcode Label Read by the Eddy Current Testing with the Dyadic Green Function Method

Analysis of Dipole-Like Ultra High Frequency Rfid Tags Close to Metallic Surfaces

RFID Antenna Near the Surface of Metal

Electromagnetic field analysis and modeling of a relative position detection sensor for high speed maglev trains

A numerical simulation method of residual magnetic field signals for evaluating deformation-induced stress concentration in ferromagnetic materials

Basic analysis of a metal detector

Analysis of Damage ' s Influences on Metal

Testing and Analysis of Tangential Component Signals of Metal Magnetic Memory

Numerical studies to signal characteristics with the metal magnetic memory-effect in plastically deformed samples

In-Situ Magnetic Barkhausen Noise Measurements to Identify Elastic-Plastic Deformation and Failure in Different Steels

The metal magnetic memory detection of rotating bending fatigue damage for 45QT steel

Passive UHF RFID Tag As a Sensor for Crack Depths

The Relativity Between Metal'S S-N Curve And The Magnetic Signals In Tangent Direction

Research of RFID Tag Used in Metallic Object Identification

Relationship Between Residual Plastic Deformation and Metal Magnetic Memory Signals of Specimens