Abstract:Background The TRS‐483, an IAEA/AAPM International Code of Practice on dosimetry of small static photon fields, underwent testing via an IAEA coordinated research project (CRP). Alongside small field output factors (OFs) measurements using active dosimeters by CRP participants, the IAEA Dosimetry Laboratory received a mandate to formulate a remote small field dosimetry audit method using its passive dosimetry systems. Purpose This work aimed to develop a small field dosimetry audit methodology employing radiophotoluminescent dosimeters (RPLDs) and radiochromic films. The methodology was subsequently evaluated through a multicenter pilot study with CRP participants. Methods The developments included designing and manufacturing a dosimeter holder set and the characterization of an RPLD system for measurements in small photon fields using the new holder. The audit included verification of small field OFs and lateral beam profiles for small fields. At first, treatment planning system (TPS) calculated OFs were checked against a reference data set that was available for conventional linacs. Second, calculated OFs were verified through the RPLD measurement of point doses in a machine‐specific reference field, 4 cm × 4 cm, 2 cm × 2 cm, and 1 cm × 1 cm, corresponding size circular fields or nearest achievable field sizes. Lastly, profile checks in in‐plane and cross‐plane directions were done for the two smallest fields by comparing film measurements with TPS calculations at 20%, 50%, and 80% isodose levels. Results RPLD correction factors for small field measurements were approximately unity. However, they influenced the dose determination's overall uncertainty in small fields, estimated at 2.30% (k = 1 level). Considering the previous experience in auditing reference beam output following the TRS‐398 Code of Practice, the acceptance limit of 5% for the ratio of the dose determined by RPLD to the dose calculated by TPS, DRPLD/DTPS, was considered adequate. The multicenter pilot study included 15 participants from 14 countries (39 beams). Consistent with the previous findings, the results of the OF check against the reference data confirmed that TPSs tend to overestimate OFs for the smallest fields included in this exercise. All except three RPLD measurement results were within the acceptance limit, and the spread of results increased for smaller field sizes. The differences between the film measured and TPS calculated dose profiles were within 3 mm for most of the beams checked; deviated results revealed problems with TPS commissioning and calibration of the treatment unit collimation systems. Conclusion The newly developed small field dosimetry audit methodology proved effective and successfully complemented the CRP OF measurements by participants with RPLD audit results.

Investigating the impact of new dosimetric quantities recommended by ICRU 95 on the OSLd individual monitoring system at OAP, Thailand

Implications of the ICRU 95 quantities for various personal dosimetry techniques

Assessment of occupational dose during abdominal fluoroscopic-guided procedures in Thailand using nanoDot OSL dosimeters

Surface dose measurement by optically stimulated luminescent dosimeter: A phantom study

PERSONAL DOSIMETRY USING MONTE-CARLO SIMULATIONS FOR OCCUPATIONAL DOSE MONITORING IN INTERVENTIONAL RADIOLOGY: THE RESULTS OF A PROOF OF CONCEPT IN A CLINICAL SETTING

Lifetime extension of optically stimulated luminescent dosimeters above 10 gy

An efficient protocol for commissioning radiophotoluminescence dosimeters for radiotherapy dosimetry audits

Response of Photon Dosimeters and Survey Instruments to New Operational Quantities Proposed by ICRU RC26

OSL and PTOSL of dosimetric materials: Observation of the luminescence after exposure to 90 Sr+ 90 Y source and LEDs in ultraviolet range

EP-1484: the Dosimetric Property of TLD2000 Thermoluminescent Dosimeter

DETERMINING THE DOSE RATE DEPENDENCE OF DIFFERENT ACTIVE PERSONAL DOSEMETERS IN STANDARDIZED PULSED AND CONTINUOUS RADIATION FIELDS

Implementation of optically simulated luminescent dosimeter for quality control of gamma ray dose of an accelerator‐based neutron source

Dosimetry of ultra-high dose rate electron beams using thermoluminescence and optically stimulated luminescence detectors

Beam quality conversion factor of BeO-OSLD for high-energy photon beams

The IAEA remote audit of small field dosimetry for testing the implementation of the TRS‐483 code of practice

Advanced lung imaging with photon-counting detectors: Insights from thermoluminescence dosimetry

Surface dose measurement and comparison between TLD and OSLD during modified re constructive mastectomy irradiation

A Review: Photonic Devices Used for Dosimetry in Medical Radiation

A methodology for on-board CBCT imaging dose using optically stimulated luminescence detectors

Comparison of the performance of two thermoluminescent dosimetry systems for the personal dose-equivalent H p(10) measurement

New model for explaining the over-response phenomenon in percentage of depth dose curve measured using inorganic scintillating materials for optical fiber radiation sensors.