Abstract:Background: Sophisticated modern radiation therapy treatments require comprehensive validation in 3D. Purpose: Investigation and characterization of a novel 3D dosimetry system consisting of ClearView radiochromic gel dosimeters (commercially available from Modus Inc) and an in-house telecentric optical CT scanner DLOS (the Duke Large Field of View Optical-CT Scanner). Methods: Spectrophotometry measurements were made on small volumes of ClearView gel irradiated with 6X photon doses up to 40 Gy to determine linearity and temporal stability of dose response. Clinical evaluation of Clearview/DLOS system was conducted in two phases. Phase one involved simple photon and electron benchmark irradiations, delivered to 15 and 10 cm diameter dosimeters, at various energies and doses. Phase 2 investigated application to the verification of two single isocenter multi-target (SIMT) stereotactic radiosurgery (SRS) deliveries. These were patient treatments for two and five brain lesions, respectively, and delivered to 15 cm diameter dosimeters. SIMT treatments were delivered by Varian TrueBeam 6X with doses of 40 Gy. For dose read-out, dosimeters were optically scanned in the DLOS both pre- and post- irradiation (within 24 h). 3D reconstructions (1 mm3 resolution) of the change in linear-optical- attenuation (proportional to dose) was obtained using in-house software and 3D Slicer. Measured and predicted (Eclipse TPS) doses were compared through percent depth-dose (PDD), cross plane and in-plane profiles, and relative 3D gamma analysis (performed at a range of 7%/4 mm down to 2%/2 mm). Regions of known artifacts were excluded from analysis (jar base, neck, and wall). The SIMT SRS deliveries were additionally compared to SciMoca, an independent Monte Carlo second check software. Results: Linearity of dose response was confirmed with R2 ≥ 0.9986 at both 520 and 630 nm wavelengths and at three post-irradiation time points: 21 h, 6 and 10 days. Dose profiles of all benchmark irradiations, in both 15 and 10 cm dosimeters, show good agreement in useable areas of the gel compared to Eclipse dose calculations, with root mean square errors (RMSE) ≤ 0.0054, and R2 ≥ 0.9808. Gamma pass rates for the 15 cm dosimeter benchmark irradiations were ≥ 94% at 2%/2 mm (central axis), ≥ 90% at 3%/3 mm (left lateral), ≥ 90% at 2%/2 mm (electron), and ≥ 94% at 3%/2 mm (stacking field). Similar high passing rates were observed for benchmark irradiations to the smaller 10 cm diameter dosimeters. Very high Gamma pass rates were found for SIMT SRS deliveries, with 99.82% and 97.80% at 3%/2 mm, for the two and five target plans, respectively. Conclusion: This work presents the first investigation of ClearView dosimeters in combination with a telecentric optical-CT scanner (DLOS). Simple benchmark irradiations demonstrate ClearView/DLOS can accurately recreate and measure relative 3D dose within non-artifact regions (i.e., > 1 cm away from walls). Application to SIMT SRS deliveries demonstrated the viability of the system as a means for comprehensive 3D verification of complex treatment deliveries as well as confirming the treatment planning system dose distribution. The results indicate that DLOS/ClearView system is a highly effective 3D verification tool for SIMT irradiations and can be applied with 3%/2 mm gamma criteria where passing rates of > 95% are to be expected.

A methodology for on-board CBCT imaging dose using optically stimulated luminescence detectors

Surface dose measurement by optically stimulated luminescent dosimeter: A phantom study

Dose measurements for dental cone-beam CT: a comparison with MSCT and panoramic imaging

Evaluation of normal organ doses for extended kV- CBCT protocol in para-aortic region treatment using nanoDot dosimeter

OSLD nanoDot characterization for carbon radiotherapy dosimetry

Evaluation of a Scintillating Plastic Optical Fiber Device for Measuring kV-Cone Beam Computed Tomography Dose

SU‐E‐J‐07: A Preliminary Study on Optimal Dose‐Allocation Parameters for Low‐Dose Cone‐Beam CT

[Measurement of scatter radiation on MDCT equipment using an OSL dosimeter]

SU-GG-T-598: Dose Calculation with MV CBCT Images for Head and Neck from a New Imaging Beam Line

Investigation of a 3D dosimetry system utilizing radio-chromic gel and telecentric optical-CT readout

Clinical applicability of Linac-integrated CBCT based NIPAM 3D dosimetry: a dual-institutional investigation

A comprehensive study on the relationship between image quality and imaging dose in low-dose cone beam CT

Optically stimulated luminescence dosimeters for simultaneous measurement of point dose and dose-weighted LET in an adaptive proton therapy workflow

A cone-beam optical CT based on a convergent light source - Characterization and optimization

Megavoltage cone beam computed tomography: Commissioning and evaluation of patient dose

Low-dose megavoltage cone-beam CT imaging using thick, segmented scintillators

Advanced Computational Methods for Radiation Dose Optimization in CT

Development of a novel automated algorithm for patient dosimetry in computed tomography: a step towards the facilitation of size-specific dose estimates and organs dosimetry estimations in a busy clinical workflow

Implementation of Ultra-Low-dose CBCT for Routine 2D Orthodontic Diagnostic Radiographs: Cephalometric Landmark Identification and Image Quality Assessment

Implementation of optically simulated luminescent dosimeter for quality control of gamma ray dose of an accelerator‐based neutron source

Comprehensive procedure for personalized dosimetry in computed tomography