CMT-based wire arc additive manufacturing of Inconel 625 alloy
Ji Junwen,Anatoliy Zavdoveev,Dmytro Vedel,Thierry Baudin,Sviatoslav Motrunich,Ilya Klochkov,Sabine Friederichs,Natalia Strelenko,Mykola Skoryk,J Junwen,A Zavdoveev,D Vedel,T Baudin,S Motrunich,I Klochkov,S Friederichs,N Strelenko,M Skoryk
DOI: https://doi.org/10.1680/jemmr.23.00053
2023-07-14
Emerging Materials Research
Abstract:Cold metal transfer (CMT) technology is considered in an application for wire arc additive manufacturing WAAM of refractory high corrosion resistant Inconel 625 alloy. Based on the fabricated wall it has been shown the suitability of CMT WAAM for the sound formation of weld and homogenous distribution of mechanical properties has been shown. Microscopy analysis has revealed that the microstructure of the deposited alloy along the height of the wall element is relatively uniform. The minor differences in the microstructure are observed in the bottom part, caused by welding specifically. It should be noted that there is a slight decrease in strength indicators from the bottom to the top of the welded product, but they do not exceed 5%, which is considered entirely satisfactory. This phenomenon is caused by structural transformations that take place in slightly different cooling conditions, namely in the lower layers, the substrate on which the surfacing was carried out plays a more significant role in heat flow. This leads to more intensive cooling of the lower layers and as a result slightly higher values of strength.
materials science, multidisciplinary