Abstract:Summary Material properties and geometrical shape of rolled products are two of the most important problems in steel product, which are affected by the thermal distribution and deformation behavior during rolling. Analysis of the behavior of medium plate during multi-pass rolling is significant for guiding the production. Recently years, the finite element method (FEM) has been widely used for analyzing the plate rolling processes, which has become an irreplaceable theory method. Rolling processes is a kind of continuous metal forming technology. Through multi-pass rolling processes, the shape and microstructure of plate could be obtained. However, in mostly works, the researchers focused on analysis of behavior of plates in a single pass, which the deformation of plate in previous passes are neglected. Itis obviousthatmore helpfulmassagescouldbeobtainedtoanalyze the behavior of plate deformation behavior in continuous multi-pass rolling processes. In this paper, a three-dimensional thermal-mechanical finite element model is established for simulation of the continuous deformation behavior of medium plate during multi-pass rolling processes coupled with explicit dynamic FEM, implicit FEM and updating geometrical method. Firstly, establishand solve thethermo-mechanical FE model of the i pass. Then obtain the thermal distribution on plate and obtain the plate shape after the i pass using the updating geometrical method. And establish and solve the thermal distribution of plate between the i pass and the i+1 pass. The thermal distribution in plate, the plate shape, etc, during rolling in the i pass are obtained. Modify the rolls gap and metrical parameters, the FE model of the i+1 pass could be established with the geometrical model and thermal distribution when i < N. With the same method, the following passes could be simulated. The plate view pattern, the thermal distribution, the maximum temperature on slab surface, the minimum temperature on slab surface and the mean temperature on slab surface each pass in the rolling processes were obtained. The calculated results are compared with the actual results, which are in good agreement. The model could be used in the hot working process.

Simulation study of plate pre-straightening process based on finite element method

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Research on key technologies for straightening pocketed aircraft frame parts

[Systemic treatment of psoriasis by fumaric acid derivatives].

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Study on key technologies of straightening large-scale integrated part's distortion due to machining

The influence of neutral layer offset on the straightening force in the process of bimetal composite plate straightening

The Causes and Control of Longitudinal Edge Cracks of the Plate

Calculation method and analysis of residual stress in the strip bending roller straightening process

FEM model optimization study of mechanical properties and material selection in stamping process

Study on deformation difference between the contact zone and the non-contact zone of the flexible 3D stretch bending profile and roller dies based on pre-stretching amount

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Crack mechanism and experimental verification on straightening of AZ31B magnesium alloy plate

Experimental and numerical investigation on static and dynamic characteristics for curvilinearly stiffened plates using DST–BK model

Simulation, microstructure and austenite reconstruction of a medium carbon micro-alloyed steel subjected to an austenitising bending process

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

Finite element analysis of residual stresses and thin plate distortion after face milling

Research on the Mechanism and Processability of Roll Forming

Three-dimensional Finite Element Analysis for Flying Shearing of X100 Hot-rolled Steel Plate

Finite Element Simulation For Blanking Process Of Sheet Metal