Abstract:The introduction of heterostructures is a new approach in gas sensing due to their easy and quick transport of charges. Herein, facile hydrothermal and solid-state techniques are employed to synthesize an α-Fe2O3/Nb2O5 heterostructure. The morphology, microstructure, crystallinity and surface composition of the synthesized heterostructures are investigated by scanning electron microscope, transmission electron microscope, x-ray diffraction, x-ray photoelectron spectroscopy and Brunauer–Emmett–Teller analyses. The successful fabrication of the heterostructures was achieved via the mutual incorporation of α-Fe2O3 nanorods with Nb2O5 interconnected nanoparticles (INPs). A sensor based on the α-Fe2O3(0.09)/Nb2O5 heterostructure with a high surface area exhibited enhanced gas-sensing features, maintaining high selectivity and sensitivity, and a considerable recovery percentage towards ethanol gas. The sensing response of the α-Fe2O3(0.09)/Nb2O5 heterostructure at lower operating temperature (160 °C) is around nine times higher than a pure Nb2O5 (INP) sensor at 180 °C with the flow of 100 ppm ethanol gas. The sensors also show excellent selectivity, good long-term stability and a rapid response/recovery time (8s/2s, respectively) to ethanol. The superior electronic conductivity and upgraded sensitivity performance of gas sensors based on the α-Fe2O3(0.09)/Nb2O5 heterostructure are attributed due to its unique structural features, high specific surface area and the synergic effect of the n–n heterojunction. The promising results demonstrate the potential application of the α-Fe2O3(0.09)/Nb2O5 heterostructure as a good sensing material for the fabrication of ethanol sensors.

Ethanol Gas Sensor Based on a Hybrid Polymethyl Methacrylate–Silica Microfiber Coupler

Polymer Film Coated Micro/Nanofiber for Gas Sensing

Room-Temperature Ethanol Sensors Based on Amorphous Ta2O5/Pd Hybrid Microspheres

Design of Highly Sensitive and Selective Ethanol Sensor Based on Α-Fe2o3/nb2o5 Heterostructure.

Sensors for Organic Vapor Detection Based on Composites of Carbon Nonotubes Functionalized with Polymers

A reusable optical fiber sensor for ethanol gas detection with a large concentration range

High sensitivity ethanol vapor sensor based on a nematic liquid crystal film embedded optical fiber Sagnac interferometer

Highly selective ethanol vapour sensing materials for a new generation of gas sensors based on molecularly imprinted polymers

Gas Sensor Based on Surface Enhanced Raman Scattering

An Ethanol Vapor Sensor Based on a Microfiber with a Quantum-Dot Gel Coating.

Development of a Sensitive Gas Sensor by Trapping the Analytes on Nanomaterials and in Situ Cataluminescence Detection

Composites of Carbon Black Functionalized with Polymers As Candidates for the Detection of Methanol Vapor

A Solid Polyelectrolyte to Detect Ethanol in Hydrocarbons

Gas Microsensors Based on Polymer-Carbon Black Composites

Wireless antenna sensor with CuO@Cu-vertical graphene and cysteine-PDMS composite for ethanol gas detection

A hydrogel optical fiber sensor for rapid on-site ethanol determination

Plasmonic hybrid modes in a multifunctional ZIF-8 layer for high performance volatile organic compounds sensing

The detection of ethanol vapors based on a p-type gas sensor fabricated from heterojunction MoS2–NiCo2O4

Hybrid perovskite quantum dot-MWCNTs gas sensor for selective ethanol sensing

Novel Gas Sensor Arrays Based on High-Q SAM-Modified Piezotransduced Single-Crystal Silicon Bulk Acoustic Resonators

Porous-Silicon Assisted Hybrid Plasmonic Slot Waveguide Based On-Chip Ethanol Sensor