Abstract:This article presents a 39 GHz transceiver front-end chipset for 5G multi-input multi-output (MIMO) applications. Each chip includes two variable-gain frequency-conversion channels and can support two simultaneous independent beams, and the chips also integrate a local-oscillator chain and digital module for multi-chip extension and gain-state control. To improve the radio-frequency performance, several circuit-level improvement techniques are proposed for the key building blocks in the front-end system. Furthermore, an advanced low-temperature co-fired ceramic process is developed to package the 39 GHz dual-channel transceiver chipset, and it achieves low packaging loss and high isolation between the two transmitting (TX)/receiving (RX) channels. Both the chip-level and system-in-package (SIP)-level measurements are conducted to demonstrate the performance of the transceiver chipset. The measurement characteristics show that the TX SIP provides 11 dB maximum gain and 10 dBm saturated output power, while the RX SIP achieves 52 dB maximum gain, 5.4 dB noise figure, and 7.2 dBm output 1 dB compression point. Single-channel communication link testing of the transceiver exhibits an error vector magnitude (EVM) of 3.72% and a spectral efficiency of 3.25 bit·s−1·Hz−1 for 64-quadrature amplitude modulation (QAM) modulation and an EVM of 3.76% and spectral efficiency of 3.9 bit·s−1·Hz−1 for 256-QAM modulation over a 1 m distance. Based on the chipset, a 39 GHz multi-beam prototype is also developed to perform the MIMO operation for 5G millimetre wave applications. The over-the-air communication link for one- and two-stream transmission indicates that the multi-beam prototype can cover a 5–150 m distance with comparable throughput.

A 1.0-3.0ghz Lte Transmitter With Cim Enhancement

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 21dBm-OP1dB 20.3%-Efficiency-131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

28.8 A 21dBm-OP<inf>1dB</inf> 20.3%-Efficiency -131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A 39 GHz Dual-Channel Transceiver Chipset with an Advanced LTCC Package for 5G Multi-Beam MIMO Systems

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A 0.1&#x2013;5ghz SDR Transmitter with Dual-Mode Power Amplifier and Digital-Assisted I/Q Imbalance Calibration in 65nm CMOS

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A 0.1-5.0 GHz SDR Transmitter with Current-Mode Power-Mixer and Self-Calibration Scheme in 65 Nm CMOS

A Power-Area-Efficient, 3-Band, 2-Rx Mimo, Td-Lte Receiver With Direct-Coupled Adc

A 130nm CMOS direct conversion transmitter for WCDMA

A 0.1–6.0-Ghz Dual-Path SDR Transmitter Supporting Intraband Carrier Aggregation in 65-Nm CMOS

A Triple-Band Flexible Low-Noise Transmitter With Linearity Enhancement

A Digital ΣΔ Modulated Class-S Transmitter with Two-Step Up-conversion and Filter-less Front End

A 27.5‐43.5 GHz 65‐nm CMOS Up‐conversion Mixer with 0.42 Dbm OP1dB for 5G Applications

Cmos Rf Transmitter With Integrated Power Amplifier Utilizing Digital Equalization

A High-Linearity WCDMA/GSM Reconfigurable Transceiver in 0.13- CMOS

A 6-Gb/s Wireline Transmitter Design with 3-Tap FFE in 28nm CMOS Technology.

A 60 Ghz Low Power Direct-Conversion Quadrature-Phase Transmitter In 130 Nm Cmos With Low Profile Cavity Backed Antenna

A 28-GHz 16-Gb/s High Efficiency 16-QAM Transmitter in 65-nm CMOS