Abstract:The Proton Improvement Plan-II (PIP-II) is a superconducting linear accelerator being built at Fermilab that will provide 800 MeV proton beam for neutrino production. The linac consists of a total of twenty-three (23) cryomodules of five (5) different types. Cooling is required at 2K, 5K and 40K. The Cryogenic Distribution System (CDS) consists of a Distribution Valve Box, ~285 m of cryogenic transfer line, modular Bayonet Cans to interface with cryomodules, and a Turnaround Can. The cryogenic system must provide protection from over-pressure by sizing pressure relief devices for all volumes and process line circuits. The cryomodule cavity circuits have dual pressure ratings, 4.1 bara when cold and 2.05 bara when warm (T>80K). Worst case relieving cases will be identified. The methods for determining heat flux will be presented. For the relieving occurring in the linac tunnel, flow must vent to outside to avoid an oxygen deficiency hazard. Also, we will present vacuum vessel relief sizing to protect the cryogenic distribution system vacuum shells from over pressure during an internal line rupture. The project is funded by US DOE Offices of Science, High Energy Physics.

Fabrication experience of the pre-production PIP-II SSR2 cavities at Fermilab

PIP-II SSR2 Cavities Fabrication and Processing Experience

Final Design of the Production SSR1 Cryomodule for PIP-II Project at Fermilab

Cold Test Results of Pre-Production PIP-II SSR2 Cavities with High-Power Couplers in the Fermilab Spoke Test Cryostat

Design, Manufacturing, Assembly, and Lessons Learned of the Pre-production 325 MHz Couplers for the PIP-II Project at Fermilab

Application Of The ASME Boiler And Pressure Vessel Code In The Design Of SSR Cryomodule Beamlines For PIP-II Project At Fermilab

Overview and status of the PIP-II cryogenic system

PIII Project Overview and Status

LLRF System for the Fermilab PIP-II Superconducting LINAC

Warm Compressor system Overview and status of the PIP-II cryogenic system

Proton Improvement Plan II Cryogenic Distribution System thermodynamic design

Final Physics Design of Proton Improvement Plan-II At Fermilab

PIP2-BD: GeV Proton Beam Dump at Fermilab's PIP-II Linac

Performance Analysis of Spoke Resonators, Statistics from Cavity Fabrication to Cryomodule Testing

Impact of Solenoid Induced Residual Magnetic Fields on The Prototype SSR1 CM Performance

Optimization of Superconducting Linac for Proton Improvement Plan-II (PIP-II)

Controls at the Fermilab PIP-II Superconducting Linac

Pressure safety approach for PIP-II cryogenic distribution system and cryomodules

Radiation Shielding Analysis for the PIP-II Linac at Fermilab

Installation, commissioning, and testing of the HB650 CM at PIP2IT

Physics Opportunities at a Beam Dump Facility at PIP-II at Fermilab and Beyond