Abstract:A new dual-bandpass 180° hybrid coupler, based on four properly designed shorted-stub loaded stepped-impedance resonators, is proposed in this paper. In order to construct the collaboratively designed coupler/filter, the resonators are coupled magnetically and electrically with each other through three shorted stubs and an open coupled line, respectively. According to the approach of filter synthesis and the derived design equations, the characteristic admittances and electrical lengths of the resonators and coupling sections are determined to achieve the desired resonant frequencies, external Q factors, and internal coupling coefficients for dual passbands. A design procedure is provided. The design flexibilities for ratios of central frequencies and achievable bandwidths are explored. The component shows both filtering and power dividing functions within two specific passbands, whose good performances are demonstrated by the simulated and measured results. The two second-order passbands of a fabricated prototype are located at 2.42 and 5.84 GHz, with 4.6% and 5.2% bandwidths, respectively. The insertion losses are 1.0 and 1.4 dB over 3-dB power division. The isolations are better than 23.5 and 32.8 dB. In both the in-phase and out-of-phase responses, the in-band amplitude and phase imbalances are always within -1.6-0.6 dB and -6.5°-9.5°, respectively.

Design, Manufacturing, Assembly, and Lessons Learned of the Pre-production 325 MHz Couplers for the PIP-II Project at Fermilab

Cold Test Results of Pre-Production PIP-II SSR2 Cavities with High-Power Couplers in the Fermilab Spoke Test Cryostat

Fabrication experience of the pre-production PIP-II SSR2 cavities at Fermilab

A Multilayer Dual-Band Coupler Based on Composite Right/left-Handed Folded Substrate Integrated Waveguide

Final Design of the Production SSR1 Cryomodule for PIP-II Project at Fermilab

Collaborative Design of a New Dual-Bandpass 180 Hybrid Coupler

Transportation Fatigue Testing of the pHB650 Power Coupler Antenna for the PIP-II Project at Fermilab

PIP-II SSR2 Cavities Fabrication and Processing Experience

High Power Conditioning of RF Couplers for the BISOL Linac

Coupler Conditioning and High Power Testing of ADS Spoke Cavity

High-Power Testing of the APT Power Coupler

Application Of The ASME Boiler And Pressure Vessel Code In The Design Of SSR Cryomodule Beamlines For PIP-II Project At Fermilab

Installation, commissioning, and testing of the HB650 CM at PIP2IT

The Radio-Frequency Design of an Iris-Type Coupler for the CPHS Radio-Frequency Quadrupole

Design and High Power Testing of 52.809 MHz RF Cavities for Slip Stacking in the Fermilab Recycler

The study and design of RF coupler for Chinese ADS HWR Superconducting Cavity

Performance Analysis of Spoke Resonators, Statistics from Cavity Fabrication to Cryomodule Testing

Optimization of Superconducting Linac for Proton Improvement Plan-II (PIP-II)

Design and technology of high-power couplers, with a special view on superconducting RF

RF thermal and new cold part design studies on TTF-III input coupler for Project-X

Final Physics Design of Proton Improvement Plan-II At Fermilab