Abstract:Glass ceramics are widely used to manufacture esthetic veneers, inlays, onlays, and crowns. Although the clinical survival rates ofglass-ceramic restorations arefavorable,fractures or chips are common. Certain cases can be repaired with direct composite. Aim: The aim of this study was to investigate the interaction effect of different designs and surface treatments on the load-to-failure of lithium disilicate glass-ceramic repaired with nanofilled composite. Materials and method: Lithium-disilicate glass-ceramic slabs (IPS e.max Press, Ivoclar Vivadent) with three different designs of the top surface (flat, single plateau, or doubleplateau) (n=U) received 'no treatment', '5% HF etching', or "AI2O3 sandblasting". HF-etched and sandblasted slabs also received silane and universal one-step adhesive application. All slabs were incrementally repaired with nanofilled composite (Filtek Z350, 3M ESPE) up to6 mm above the highest ceramic top plateau. Specimens were stored in artificial saliva at 37 °C for 21 days and then subjected to 1,000 thermocycles between 5 and 55 °C. The interface composite-ceramic of each specimen was tensile tested until failure in a universal testing machine and the mode of failure was determined under a stereomicroscope. The ceramic surface morphology of one representative tested specimen from each subgroup (design/surface treatment) was observed through scanning electron microscopy (SEM). Results: Regardless of ceramic design, the absence of surface treatment resulted in significantly lower load-to-failure values. No significant differences in load-to-failure values were observed between HF-etched and sandblasted specimens for the flat design; however, HF etching resulted in significantly higher load-to-failure values than sandblasting for both single plateau and double plateau designs. The majority (60%) of HF-etched specimens with single plateau or double plateau presented mixed failures. SEM photomicrographs showed that HF-etched specimens had smoother surfaces than sandblasted specimens. Conclusion: The surface treatment of a defective lithium disilicate glass-ceramic restoration has more influence than its macroscopic design on the retention of the composite repair. HF etching seems to provide higher bond strength to the composite repair.

Surface and Shape Defects of Ceramic Fibers of Refractory Oxides

Method of Damage Characterization of Engineering Ceramics Grinding Surface

Study of the structural changes in oxide ceramics using polarization microscopy

Experimental investigation on grinding-induced surface damage of Fiber Reinforced Ceramic Matrix Composites

Defects and Scattering Loss in Fluoride Fibers: a Review

Chemistry and Physics of Point Defects in Advanced Ceramics

Defects and Aliovalent Doping Engineering in Electroceramics

Characterization of Defects of Mullite Fibers Prepared by Polyvinyl Butyral As Spinning Aid

The Relationship Between Structural Features and Local Mechanical Properties of a Fine-Grained Matrix in Refractory Ceramic Materials. SiO2 Ceramics Case Study

Nanoscale self-healing mechanisms in shape memory ceramics

Research on the Microstructure of Ceramic Glass and Its Polished Surface Quality

A useful approach to understand the origin of defects in transparent YAG ceramics

On Defect Minimization Caused by Oxide Phase Formation in Laser Powder Bed Fusion

Main Areas for Improving Refractory Fiber-Reinforced Ceramic Matrix Composite Corrosion and Heat Resistance (Review)

Defects and solarization in YAG transparent ceramics

Improving the Quality of Ceramic Products by Removing the Defective Surface Layer

Advanced and Functional Structured Ceramics: MgF2 and ZnS

Flexural strength and fracture toughness of Dicor glass-ceramic after embedment modification

Surface Treatment of Alumina-Based Ceramics Using Combined Laser Sources

Research Progress on Subsurface Defects in Fused Silica

Effect of different design and surface treatment on the load-to-failure of ceramic repaired with composite