Influence of charge rate on the cycling degradation of LiFePO 4 /mesocarbon microbead batteries under low temperature

Yong Zheng,Yan-Bing He,Kun Qian,Dongqing Liu,Qingwen Lu,Baohua Li,Xindong Wang,Jianling Li,Feiyu Kang
DOI: https://doi.org/10.1007/s11581-017-2032-y
IF: 2.961
2017-01-01
Ionics
Abstract:The lithium-ion batteries show extremely poor cycling performance at low temperature. The main degradation mechanism is not clear. To address the fading mechanism, the cycling degradation of commercial LiFePO 4 /mesocarbon microbead (MCMB) batteries under various charge rate (1/10C, 1/3C, 1/2C, and 1C) at −10 °C is systematically investigated using nondestructive tests combining with post-mortem analysis. The low-temperature charging under high charge rates of 1/3C, 1/2C, and 1C results in severe lithium plating, which leads to extremely serious capacity loss. In contrast, no lithium plating occurred under low charge rate of 1/10C. The lithium plating on the anode surface leads to consumption of active lithium ions and electrolyte, which causes the capacity decay and increases ohmic resistance ( R b ) with cycling number under high charge rates. The lithium plating on the anode surface is partially reversible, which brings about the capacity recovery of batteries after 80 cycles at 25 °C. The above results are proved by the followed post-mortem measurements. The evolution of the surface morphologies of MCMB electrodes upon cycling shows that a layer composed of rod-like lithium is formed on the anode surface.
What problem does this paper attempt to address?