Abstract:(Ln + Nb) co-doped TiO2 polycrystalline ceramics possess remarkable dielectric behaviors, but their origin is still not fully understood. Compared to ceramic materials, a single crystal could keep most of the original material's properties and eliminate interference due to grain boundaries and pores, thereby useful for exploring the origin of the material's properties. Here, Ga3+ with a radius close to that of the Ti4+ ion was selected as an acceptor ion to study the properties. To this end, rutile single crystals and (Nb + Ga) co-doped rutile single crystals were prepared by the Verneuil method. The permittivity of the doped single crystal at frequencies from 20 Hz to 2 MHz was found to be greater than 15,000, and the dielectric loss was kept below 0.08. The latter value was much smaller than the reported values of rutile single crystal samples. Electrochemical impedance spectroscopy and X-ray photoelectron spectroscopy indicated significantly enhanced dielectric properties, mainly attributed to the highly localized electron-pinned defect dipoles rather than the surface barrier layer capacitor effect. The electrons tightly bounded by the local electric dipole defect clusters can only range over a very small distance, which made the doped crystal have a large dielectric constant over a wide frequency range and maintain a low dielectric loss. In sum, the use of single crystals as a research object greatly provided insights into the origin and optimization of giant dielectric properties of TiO2-based materials.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.cgd.1c00611.Diagram of the crystal growth process; XRD and macroscopic diagram of Nb–TiO2 and Ga–TiO2 crystals; high-magnification SEM of the NGTO crystal; and XRD peak migration image of TiO2, Nb–TiO2, Ga–TiO2, and NGTO crystals (PDF)This article has not yet been cited by other publications.

Colossal Permittivity Behavior and Its Origin in Rutile (Mg1/3ta2/3)xti1-Xo2

Defect Engineering of Rutile TiO2 Ceramics: Route to High Voltage Stability of Colossal Permittivity

Colossal Dielectric Permittivity in (al+nb) Co-Doped Ba0.4Sr0.6TiO3 Ceramics

Origin of Colossal Dielectric Permittivity of Rutile Ti0.9In0.05Nb0.05O2: Single Crystal and Polycrystalline

Large-size-mismatch co-dopants for colossal permittivity rutile TiO 2 ceramics with temperature stability

Colossal Dielectric Properties in (ta0.5al0.5)xti1−xo2 Ceramics

Colossal Permittivity, Low Dielectric Loss, and Good Thermal Stability Achieved in Ta-doped BaTiO3 by B-site Defect Engineering

Colossal Dielectric Performance of Pure Barium Titanate Ceramics Consolidated by Spark Plasma Sintering

High-performance Colossal Permittivity Behaviour Persists to Ultralow Temperature in Co+Ta Co-Doped SnO2: A Spin-Defect Mediated Superstable Large Electronic Moment of Defect-Dipole

Colossal permittivity and ferroelectric properties regulation of different kinds of doped TiO2

Enhanced Dielectric Performance of Niobium and Thulium Modified Rutile TiO2 Ceramics by Defect Regulation

Colossal Permittivity and Ferroelectric Properties Regulation of Different Kinds of Doped TiO 2

Giant dielectric response and relaxation behavior in (Tm + Ta) co-doped TiO 2 ceramics

Effect of Defect Dipoles on the Colossal Dielectric Behaviors of TiO2-x Ceramics

Colossal Dielectric Permittivity in Hydrogen-Reduced Rutile TiO2 Crystals

Origin of Colossal Dielectric Permittivity in (Nb + Ga) Co-Doped TiO 2 Single Crystals

Nonlinear I–V Behavior in Colossal Permittivity Ceramic:(Nb+in)co-Doped Rutile TiO2

Origins of Giant Dielectric Properties with Low Loss Tangent in Rutile (Mg1/3Ta2/3)0.01Ti0.99O2 Ceramic

High Performance and Colossal Permittivity of (nb+la) Co-Doped Rutile TiO2 Ceramics Induced by Composition Regulation

Synthesis and characterization of (sm, Al) co-doped SrTiO3 with giant dielectric constant and low dielectric loss through defect engineering design

Enhanced dielectric performance of Niobium and Thulium modified rutile TiO 2 ceramics by defect regulation