Abstract:Wear performance and mechanisms of PCBN tools with different CBN content (80% vol. and 95% vol.) and cutting edge geometry (honed edge radius, 0.05 mm chamfered edge width, and 0.10 mm chamfered edge width) in boring powder metallurgy (PM) steels had been evaluated. Post-cutting examination of the worn cutting inserts was performed using focus variation microscopy (FVM), scanning electron microscopy (SEM), and energy dispersive spectrometer (EDS). The advanced three-dimensional wear characterization parameters WRM, WMD, WAM, WMH, and WAA are used to measure the wear of PCBN tools. A novel characterization method of removed material (η1 = WMD/WRM) and adhered material (η2 = WMH/WAM) was used to measure the trend of tool wear in this paper. With the increasing of CBN content, the PCBN tool wear parameters WRM, WMD, and WAA were decreased; adhesion was increased by WAM and WMH parameter characterization. For the variation of cutting edge geometry, chamfered edge showed a higher tool life and better wear performance than honed edge radius. With the increasing of chamfered edge width from 0.05 to 0.10 mm, the three-dimensional wear WRM, WMD, WAM, and WMH were increased. WAA showed an opposite trend and parameters η1 and η2 showed a not convergence trend. Besides typical wear mechanisms such as diffusion, adhesion, abrasive, microchipping was observed on PCBN tool; the tool protection layer (TPL) formation and peeling and impact load could be the reasons to explain the microchipping that occurred on cutting edge. Tool life is measured by surface roughness and calculated according to the number of workpieces processed. The results showed that PCBN tool with 95% vol. CBN content and 0.10 mm chamfered edge width achieves higher tool life.

Research on Cutting Parameters of PCD Tool when Machining Wear Resistant Layer of High Pressure Laminated Flooring

Analysis on Mechanics Property of PCD Tool While Machining Ceramics Overlay of HPL Flooring

Study on wear mechanisms and grain effects of PCD tool in machining laminated flooring

Wear Behaviors of Pcd Tools in Turning Granite

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Research on Tool Wear and Surface Integrity of CFRPs with Mild Milling Parameters

Cutting performance and tool wear mechanism of corrugated helical PCD tool in milling Cf/SiC composites

Research on cutting parameters of low-temperature liquid CO 2 assisted PCD tool turning bearing ring

Cutting Performance and Wear/Damage Characteristics of PCBN Tool in Hard Milling

Research on PCBN Tool Dry Cutting GCr15

Analysis and design of PCD milling tool for machining copper alloy materials

Investigation on Cutting Performance of Micro-Textured Cutting Tools

Research on milling force in precision milling SiCp/Al composite materials

A novel hybrid micro-texture for improving the wear resistance of PCD tools on cutting SiCp/Al composites

Wear performance and mechanisms of PCBN tools in boring of powder metallurgy steels

Drilling process of Cf/SiC ceramic matrix composites: Cutting force modeling, machining quality and PCD tool wear analysis

Effect of diamond grain size on mechanical properties and cutting performance of PCD tool in milling of C f /SiC composites

Investigation of the effect of the cut parameter on the machining performance of PTFE cutting

Cutting performance and wear behavior of diamond, coated cemented carbide and PCBN tools during milling of C f /SiC composites

Study on PCD Tool Wear in Hard Milling of Fully-Sintered 3Y-TZP Ceramics

Introduction To Using Pcd Tools