Abstract:CFRP/Ti stacks have become a viable alternative to conventional composite laminates and metal alloys in various aerospace applications because of their enhanced mechanical properties and improved structural functions. Machining these multilayer stacks with acceptable quality still remains a great challenge for the modern manufacturing sectors due to the ineffective management of the tool wear performance resulting from the varying properties of the stacked constituents. This paper describes, on a fundamental basis, the wear characteristics of polycrystalline diamond (PCD) tipped tools during the orthogonal cutting of CFRP/Ti stacks. Two cutting sequence strategies, i.e., cutting from CFRP to Ti and cutting from Ti to CFRP, were implemented throughout the cutting tests. The experimental results confirm the predominance of the cutting sequence strategy in affecting the CFRP/Ti chip separation and the machined surface quality. The chip adhesion is a most influential factor leading to the disparate influences of the two cutting sequence strategies on the CFRP/Ti cutting responses. The PCD tool suffers severe crater wear due to the Ti phase cutting, while it undergoes minor flank wear owing to its superior wear resistance against abrasive carbon fibers. The wear signatures on the tool-chip contact zone via the scanning electron microscope (SEM) observation reveal that the Ti phase cutting dominates the formation of the tool crater wear land. The edge chipping occurs mainly due to the sudden force variation in the CFRP/Ti interface machining and the inherent brittleness of the PCD material. The fiber orientation seems to have a great impact on the wear behavior of utilized PCD tools by altering the tool-chip contact length.

Analysis on Mechanics Property of PCD Tool While Machining Ceramics Overlay of HPL Flooring

Study on wear mechanisms and grain effects of PCD tool in machining laminated flooring

Finite Element Analysis on Stress Distribution of PCD Tool while Machining Al2O3 Ceramics Overlay

Research on Cutting Parameters of PCD Tool when Machining Wear Resistant Layer of High Pressure Laminated Flooring

Wear Behaviors of Pcd Tools in Turning Granite

Analysis of Material Removal in Alumina Ceramic Honing

Analysis and design of PCD milling tool for machining copper alloy materials

Study on PCD Tool Wear in Hard Milling of Fully-Sintered 3Y-TZP Ceramics

Wear and breakage behaviors of PCD small-diameter end-mill: a case study on machining 2A12 aluminum alloy

Evaluation of Polycrystalline Diamond Tools in Milling of Pre-Sintered and Fully-Sintered Zirconia Ceramics

Drilling process of Cf/SiC ceramic matrix composites: Cutting force modeling, machining quality and PCD tool wear analysis

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Wear Characteristics of Polycrystalline Diamond Tools in Orthogonal Cutting of Cfrp/Ti Stacks

Tribological behavior of PDC-cutter including cemented carbide and polycrystalline diamond composites produced by HPHT for drilling applications

The Study on the Influence of Worn Tool Geometry on the Cutting Process of Ceramic Particle Reinforced Composites

Cutting performance and tool wear mechanism of corrugated helical PCD tool in milling Cf/SiC composites

A novel hybrid micro-texture for improving the wear resistance of PCD tools on cutting SiCp/Al composites

Research on Tool Wear in Machining of Particle Reinforced Aluminium Metal Matrix Composites Using PCD Tool

Cutting Performance and Wear/Damage Characteristics of PCBN Tool in Hard Milling

An Experimental Investigation on Milling Features of Fully-Sintered Zirconia Ceramics Using PCD Tools

Wear behaviors of PCD and diamond-coated tools during low-frequency vibration-assisted drilling CFRP/Ti stacks