Abstract:Die filling from a stationary shoe in a vacuum and in the presence of air was numerically, analyzed using an Eulerian-Lagrangian model, which employs a discrete element method (DEM) for the particles and computational fluid dynamics (CFD) for the air with a two-way air-particle interaction coupling term. Monodisperse and polydisperse powder systems have been simulated to explore the effect of the presence of air on the die filling process. For die filling with monodisperse powders, the influences of particle size and density on the flow behavior were explored. The numerical simulations revealed that the presence of air has a significant impact on the powder flow behavior, especially for systems with smaller and/or lighter particles. Flow has been characterized in terms of a dimensionless mass flow rate, and it has been shown that for die filling in a vacuum this is constant. The flow characteristics for die filling in air can be classified into two regimes. There is an air-inert regime in which the particle size and density are sufficiently large that the effect of air flow becomes negligible, and the dimensionless mass flow rate is essentially identical to that obtained for die filling in a vacuum. There is also an air-sensitive regime, for smaller particle sizes and lower particle densities, in which the dimensionless mass flow rate increases as the particle size and density increase. The effects of particle-size distribution and adhesion on the flow behavior have also been investigated. It was found that, in a vacuum, the dimensionless mass flow, rate for polydisperse systems is nearly identical to that for monodisperse systems. In the presence of air, a lower dimensionless mass flow rate is obtained for polydisperse systems compared to monodisperse systems, demonstrating that air effects become more significant. Furthermore, it has been shown that, as expected, the dimensionless mass flow rate decreases as the surface energy increases (i.e., for more cohesive powders). (C) 2008 American Institute of Chemical Engineers AIChE J, 55: 49-62, 2009

A Parametric Evaluation of Powder Flowability Using a Freeman Rheometer Through Statistical and Sensitivity Analysis: A Discrete Element Method (DEM) Study

A multivariate regression parametric study on DEM input parameters of free-flowing and cohesive powders with experimental data-based validation

Numerical Analysis of Air Effect on the Powder Flow Dynamics in the FT4 Powder Rheometer

Investigating mixing and segregation using discrete element modelling (DEM) in the Freeman FT4 rheometer

Analysis of Powder Rheometry of FT4: Effect of Air Flow

Discrete element modelling (DEM) input parameters: understanding their impact on model predictions using statistical analysis

The importance of a velocity-dependent friction coefficient in representing the flow behaviour of a blade-driven powder bed

Comprehensive evaluation of powder flowability for additive manufacturing using principal component analysis

A Coupled DEM/CFD Analysis of Die Filling Process

A mechanistic framework for the characterisation of cohesive, frictional and interlocking effects on powder flow behaviour

An experimentally validated DEM study of powder mixing in a paddle blade mixer

Measurement and Simulation Validation of DEM Parameters of Pellet, Sinter and Coke Particles

Techniques to Determine Powder Flow Properties

A Coupled Dem/Cfd Analysis of the Effect of Air on Powder Flow During Die Filling

Density and size-induced mixing and segregation in the FT4 powder rheometer: An experimental and numerical investigation

Using a Freeman FT4 Rheometer and Electrical Capacitance Tomography to Assess Powder Blending

Characterization of Non-Newtonian Rheological Behaviors of Powders

Characterization of Powder Flow Properties from Micron to Nanoscale Using FT4 Powder Rheometer and PT-X Powder Tester

A novel methodology for data analysis of dynamic angle of repose tests and powder flow classification

DEM simulation of the powder application in powder bed fusion

Numerical modelling of suction filling using DEM/CFD