Abstract:Die filling from a stationary shoe in a vacuum and in the presence of air was numerically, analyzed using an Eulerian-Lagrangian model, which employs a discrete element method (DEM) for the particles and computational fluid dynamics (CFD) for the air with a two-way air-particle interaction coupling term. Monodisperse and polydisperse powder systems have been simulated to explore the effect of the presence of air on the die filling process. For die filling with monodisperse powders, the influences of particle size and density on the flow behavior were explored. The numerical simulations revealed that the presence of air has a significant impact on the powder flow behavior, especially for systems with smaller and/or lighter particles. Flow has been characterized in terms of a dimensionless mass flow rate, and it has been shown that for die filling in a vacuum this is constant. The flow characteristics for die filling in air can be classified into two regimes. There is an air-inert regime in which the particle size and density are sufficiently large that the effect of air flow becomes negligible, and the dimensionless mass flow rate is essentially identical to that obtained for die filling in a vacuum. There is also an air-sensitive regime, for smaller particle sizes and lower particle densities, in which the dimensionless mass flow rate increases as the particle size and density increase. The effects of particle-size distribution and adhesion on the flow behavior have also been investigated. It was found that, in a vacuum, the dimensionless mass flow, rate for polydisperse systems is nearly identical to that for monodisperse systems. In the presence of air, a lower dimensionless mass flow rate is obtained for polydisperse systems compared to monodisperse systems, demonstrating that air effects become more significant. Furthermore, it has been shown that, as expected, the dimensionless mass flow rate decreases as the surface energy increases (i.e., for more cohesive powders). (C) 2008 American Institute of Chemical Engineers AIChE J, 55: 49-62, 2009

A mechanistic framework for the characterisation of cohesive, frictional and interlocking effects on powder flow behaviour

Research Progress of Granular Flow and Fluidization Behavior of Coarse Cohesive Particles

Cohesive Powder Flow: Trends and Challenges in Characterisation and Analysis

The Effect of Process Conditions on Powder Flow Properties for Slow Flow Regimes

Investigation on the Friction Mechanism and Its Relation to the Force Chains During Powder Compaction

A novel methodology for data analysis of dynamic angle of repose tests and powder flow classification

The importance of a velocity-dependent friction coefficient in representing the flow behaviour of a blade-driven powder bed

Relation Between Force Chain Quantitative Characteristics and Side Wall Friction Behaviour During Ferrous Powder Compaction

Correlation Mechanism Between Force Chains and Friction Mechanism During Powder Compaction

Some Considerations on the Rheology of Dense Frictional Cylindrical Particles

Characterization and flowability methods for metal powders

Comprehensive evaluation of powder flowability for additive manufacturing using principal component analysis

Techniques to Determine Powder Flow Properties

General aspects of powder rheology applied to pharmaceutical formulations

A multivariate regression parametric study on DEM input parameters of free-flowing and cohesive powders with experimental data-based validation

A Coupled Dem/Cfd Analysis of the Effect of Air on Powder Flow During Die Filling

Validation of Surface Coating with Nanoparticles to Improve the Flowability of Fine Cohesive Powders

Rheology of Sheared Polyhedral Granular Materials in Inclined Flows

Rheology of powders and nanopowders through the use of a Couette four-bladed vane rheometer: flowability, cohesion energy, agglomerates and dustiness

Modeling and characterization of cohesion in fine metal powders with a focus on additive manufacturing process simulations

Characterisation of the flow behaviour of pharmaceutical powders using a model die–shoe filling system