Abstract:The flow and segregation behaviours of the binary mixtures with different particle sizes during die filling in air and in a vacuum were investigated using a coupled discrete element method (DEM) and computational fluid dynamics (CFD) in three dimensions (3D). Two types of computational setups were considered: i) a fully 3D model with real wall boundaries and ii) a thin sliced model with a slice of the full domain using two parallel periodic boundaries. Die filling with a stationary shoe and a moving shoe were simulated. It was found that the flow and segregation results obtained using the fully 3D and thin sliced models were essentially identical, implying that the thin sliced model can be used to simulate the die filling with a reduced computational time and good accuracy. It was also observed that, for die filling with a stationary shoe, the powder flow rate was reduced by the entrapped air in the die. For the die filling in a vacuum, vertical segregation occurred with a high concentration of fine particles at the bottom of the die as the fine particles can sift through the voids between coarse particles. The presence of air reduced the extent of this segregation by suppressing the percolation of fines through the voids. For die filling with a moving shoe, the effect of air on powder flow and segregation behaviours is negligible when the process is dominated by nose flow as considered in this study, since the air can readily escape from the die cavity. Segregation was also induced during die filling with a moving shoe, due to the free surface segregation and the filtration of fines through the voids between the coarse particles. Consequently, a high overall concentration of fines in the die was obtained, while the concentration of fines at the far end of the die was much lower than that at the near end.

Density and size-induced mixing and segregation in the FT4 powder rheometer: An experimental and numerical investigation

DEM Study of the Size-Induced Segregation Dynamics of a Ternary-Size Granular Mixture in the Rolling-Regime Rotating Drum

The effects of air and particle density difference on segregation of powder mixtures during die filling

Numerical analysis of density-induced segregation during die filling

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

Effect of particle angularity on flow regime transitions and segregation of bidisperse blends in a rotating drum

Near-Infrared Identification of the Dimmest X-ray Sources on the Galactic Plane with the ESO/NTT SOFI Camera

3D DEM/CFD analysis of size-induced segregation during die filling

DEM investigation of the axial dispersion behavior of a binary mixture in the rotating drum

Dense granular flow of mixtures of spheres and dumbbells down a rough inclined plane: Segregation and rheology

The importance of a velocity-dependent friction coefficient in representing the flow behaviour of a blade-driven powder bed

A Coupled DEM/CFD Analysis of Die Filling Process

Rheology of Sheared Polyhedral Granular Materials in Inclined Flows

The Rheology of Granular Mixtures with Varying Size, Density, Particle Friction and Flow Geometry

Rheology of powders and nanopowders through the use of a Couette four-bladed vane rheometer: flowability, cohesion energy, agglomerates and dustiness

Numerical and Experimental Study of Radial Segregation of Bi-Disperse Particles in a Quasi-Two-dimensional Horizontal Rotating Drum

Designing non-segregating granular mixtures

DEM simulations: mixing of dry and wet granular material with different contact angles

Experimental investigation into segregation behavior of spherical/non-spherical granular mixtures in a thin rotating drum

Investigation of particle segregation in a vertically vibrated binary mixture: Segregation process and mechanism

Rheology of granular mixtures with varying size, density, particle friction, and flow geometry