Abstract:Transmission measurements of radiation through process pipes provide a non-intrusive method of determining the amount of product present in the pipes. The product could be a liquid, a slurry, or a gas, which is the most challenging because of the low density. Traditionally, these techniques have used a radioactive source that has to be replaced periodically. We have developed a transmission technique based on an X-ray tube instead of a decaying source. A notch filter is used to provide a narrow transmission line, and a thin silicon transmission detector is used to monitor the X-ray tube output. The transmitted X-rays are measured with a high-throughput gamma spectrometer that consists of a NaI(Tl) detector and an MCA with precise dead time correction. This spectrometer provides stable transmission measurements with an accuracy of a fraction of a percent. The shielding and collimator are made of machinable tungsten for thermal mechanical stability, as well low-cost, low-weight tungsten powder in polymer castings. We describe two methods of measuring the pipe wall thickness without evacuating the pipe. Our particular application was for enrichment monitors for UF(6) in process pipes. Enrichment monitors that are independent of the plant data require two measurements: a transmission measurement to determine the total amount of uranium in the pipe and a measurement of the 186-keV gamma-ray line to determine the amount of (235)U present. The ratio of these values gives the enrichment. Previous designs used a decaying radioactive source such as (57)Co (122 keV, T(½)=272 days) or (109)Cd (22 keV, T(½)=1.2 years). A major effort was required to access and periodically replace these sources in operating plants. In this report, we describe the use of an X-ray tube, which eliminated the source problem, and other innovations. Then we present data from an enrichment monitor that incorporates these innovations.

A Novel X-ray Tube Spectra Reconstruction Method Based on Transmission Measurements

A robust X-ray tube spectra measuring method by attenuation data

A Simulation Study on the Flash X-Ray Spectra Spatial Distribution

Model-Based Tungsten Anode X-ray Tube Spectra Reconstruction Method

X-ray Measurement System Based on Attenuation Transmission Method for Tokamak

Measurement and Application of Original Spectrum and Transmission Spectrum of X-ray Tube

X-Ray Spectral Reconstruction Methods Based on Transmission Measurements

High-energy X-ray spectrum reconstruction: solving the inverse problem from optimized multi-material transmission measurements

A Robust Method Of X-Ray Source Spectrum Estimation From Transmission Measurements: Demonstrated On Computer Simulated, Scatter-Free Transmission Data

Spectral Reconstruction Of The Flash X-Ray Generated By Dragon-I Lia Based On Transmission Measurements

Research on X-ray Tube Characteristics Facing X-ray Fluorescence Spectrometer

Reconstruction of X-Ray Tube Spectra from Attenuation Data

X-ray Spectrum Estimation from Transmission Measurements Using the Expectation Maximization Method

A Novel Method for Determining Source Spectrum/detector Spectral Response in X-ray Imaging

Spectrum Reconstruction Method Based on the Detector Response Model Calibrated by X-Ray Fluorescence

New technology for transmission measurements in process pipes

Calibration and Monte Carlo Simulation of A Single-Photon Counting Charge-Coupled Device for Single-Shot X-Ray Spectrum Measurements

A Novel Compact Tokamak Hard X-Ray Diagnostic Detector

[Development of X-ray excited fluorescence spectrometer].

X-Ray Spectrum Estimation from Transmission Measurements by an Exponential of A Polynomial Model

High Energy X-ray Compton Spectroscopy Via Iterative Reconstruction