Abstract:The key to recovering waste LiFePO 4 (LFP) is the recovery of lithium; however, the effective and synchronous recovery of phosphorus and iron resources still needs to be achieved. In this paper, a new process was proposed for recovering phosphorus and iron from the lithium extraction slag (LES) of waste LFP by the leaching and precipitation method. Based on the thermodynamic analysis of Fe 3+ and PO 4 3− and XRD results, the experimental conditions were discussed in detail. There were three stable regions when the solution pH value was from 0 to 5, no precipitation at pH = 0–0.664, stable existence of FePO 4 (s) at pH = 0.664–1.203, coexistence of FePO 4 (s), and AlPO 4 (s) when pH > 1.203, respectively. The leaching solution of LES by hydrochloric acid could prepare FePO 4 ·2H 2 O under the following optimal conditions: 95°C, pH 1.5, feeding speed 1.5 mL min −1 . The synthesised iron phosphate was pure and distributed in flakes. Additionally, the discharge capacity of the LiFePO 4 /C prepared by the regenerative FePO 4 ·2H 2 O was 147 mAh g −1 at 0.1 C and showed good cycle stability at 1 C. The method not only recovers FePO 4 from the LES but also shows simple operation and high efficiency. La clé pour récupérer les déchets de cathode LiFePO 4 (LFP) est la récupération du lithium, mais il est encore nécessaire d'atteindre une récupération efficace du phosphore et du fer de manière synchrone. Dans cet article, nous proposons un nouveau procédé de récupération du phosphore et du fer des scories d'extraction du lithium (LES) des déchets de LFP par lixiviation et précipitation. Sur la base de l'analyse thermodynamique des résultats de Fe 3+ et de PO 4 3− et de XRD, on a discuté en détail des conditions du procédé. Il y avait trois régions stables au pH = 0–5, aucune précipitation au pH = 0–0.664, existence stable de FePO 4 (s) au pH = 0.664–1.203, coexistence de FePO 4 (s) et AlPO 4 (s) au pH >1.203, respectivement. La solution de lixiviation du LES par l'acide chlorhydrique pourrait préparer du FePO 4 •2H 2 O dans les conditions optimales suivantes: 95°C, pH = 1.5, vitesse d'alimentation de 1.5 mL min −1 . Le phosphate de fer synthétisé était pur et distribué en flocons. De plus, la capacité de décharge du LiFePO 4 /C préparé par le FePO 4 •2H 2 O régénératif était de 147 mAh g −1 à 0.1 C et montre une bonne stabilité du cycle à 1 C. Non seulement la méthode récupère le FePO 4 du LES, mais elle présente également un fonctionnement simple et de haute efficacité.

Sequential separation and recovery of phosphorus and lithium from lithium phosphate slag by selective extraction-precipitation

Removal of impurity metals as phosphates from Lithium-ion battery leachates

Lithium Recovery from an Alumina Electrolysis Slag Leaching Solution with Strong Acidity: Separation of Lithium-Ion and Production of Battery Grade Lithium Carbonate

High-efficiency leaching process for selective leaching of lithium from spent lithium iron phosphate

A green process for phosphorus recovery from spent LiFePO4 batteries by transformation of delithiated LiFePO4 crystal into NaFeS2

Recovery of battery-grade products from mixed spent LiFePO4/LiMn2O4 cathodes via slurry electrolysis

The recovery of high purity iron phosphate from the spent lithium extraction slag by a simple phosphoric acid pickling

Study on efficient and synergistic leaching of valuable metals from spent lithium iron phosphate using the phosphoric acid-oxalic acid system

Synthesizing LiFePO4 by phosphate & iron recovered from sludge-incinerated ash and Li extracted from concentrated brines

Recovering phosphorus and lithium separately from wastewater and brine using a novel coupled biofilm-precipitation system

Study on the behavior of impurity removal from lithium iron phosphate slag using the ultrasonic-assisted sulphuric acid leaching

Study on selective recovery of lithium ions from lithium iron phosphate powder by electrochemical method

Acid-Free and Selective Extraction of Lithium from Spent Lithium Iron Phosphate Batteries Via a Mechanochemically Induced Isomorphic Substitution

A fast and efficient method for selective extraction of lithium from spent lithium iron phosphate battery

Recovery of rare earths and lithium from rare earth molten salt electrolytic slag by lime transformation, co-leaching and stepwise precipitation

Selective Precipitation of REE-Rich Aluminum Phosphate with Low Lithium Losses from Lithium Enriched Slag Leachate

Extraction of lithium as lithium phosphate from bauxite mine tailings via mixed acid leaching and chemical precipitation

A green recyclable process for selective recovery of Li and Fe from spent lithium iron phosphate batteries by synergistic effect of deep eutectic solvent and oxygen

Selective Separation and Recovery of Li from Spent LiFePO4 Cathode Materials by Oxidation Roasting Followed by Low-Acid Pressure Leaching

A Facile Recovery Process for Cathodes from Spent Lithium Iron Phosphate Batteries by Using Oxalic Acid

Efficient recovery of phosphorus and iron from the lithium extraction slag by the leaching precipitation method