Abstract:A new recovery method for fast and efficient selective leaching of lithium from lithium iron phosphate cathode powder is proposed. Lithium is expelled out of the Oliver crystal structure of lithium iron phosphate due to oxidation of Fe<math>2+</math> into Fe<math>3+</math> by ammonium persulfate. 99% of lithium is therefore leached at 40 °C with only 1.1 times the amount of ammonium persulfate without the help of acid treatment. The use of ammonium persulfate also avoids the necessity to remove other metal ions in the later purification process. Various characterization methods including SEM, XPS, XRD are used to explore the experimental leaching mechanism. Theoretical investigations are performed which reveals the E-pH diagram of Fe–P–Li–H2O thermodynamic equilibrium. It confirms the possibility and suggests appropriate pH range allowing direct conversion from lithium iron phosphate to iron phosphate with great energy saving and reduced use of acid and base. Based on the experimental and theoretical results, a green and efficient closed-loop recycling route for lithium iron phosphate is proposed.

What problem does this paper attempt to address?

### What problems does this paper attempt to solve? This paper aims to develop a fast and efficient method for selectively extracting lithium from discarded lithium iron phosphate batteries (LiFePO₄). Specifically, the research addresses the following key issues: 1. **Resource recovery and environmental issues**: - The number of discarded lithium - ion batteries is huge, especially lithium iron phosphate batteries (LFP). Improper disposal of their waste will lead to serious environmental pollution and resource waste. - With the rapid development of electric vehicle technology, a large number of discarded LFP batteries require effective recycling methods to ensure the sustainable use of lithium resources. 2. **Limitations of existing recycling methods**: - **Direct repair method**: Although the waste LFP materials can be restored to new LFP materials by high - temperature sintering, this method is difficult to maintain the consistency of the materials and is prone to introduce impurities, resulting in a decline in electrochemical performance. - **Wet - recycling method**: Traditional wet - recycling usually uses inorganic acids (such as sulfuric acid, phosphoric acid, etc.) to dissolve waste materials. This not only consumes a large amount of acid and alkali but also generates a large amount of wastewater, increasing the treatment cost and environmental burden. 3. **The proposed new method**: - The research proposes a selective leaching method using ammonium persulfate ((NH₄)₂S₂O₈) as an oxidant. By oxidizing Fe²⁺ to Fe³⁺, lithium is released from the olivine structure, thereby achieving efficient selective lithium extraction. - This method avoids the need for acid treatment, reduces the introduction of metal - ion impurities, and is more convenient in the subsequent purification process. 4. **Optimization of reaction conditions**: - By systematically studying various experimental parameters (such as the amount of ammonium persulfate, temperature, reaction time, and solid - to - liquid ratio), the optimal reaction conditions are determined: the temperature is 40 °C, the amount of ammonium persulfate is 1.1 times the theoretical amount, the reaction time is 1 hour, and the solid - to - liquid ratio is 100 g/L. - Under these conditions, the leaching rate of lithium reaches 99%, and the crystal structure and morphology of LFP are not significantly changed. 5. **Closed - loop recycling route**: - Based on the above research results, a green and efficient closed - loop recycling route is proposed. Battery - grade lithium hydroxide is obtained by electrolyzing Li₂SO₄ solution, and ammonium persulfate is regenerated after concentrating the mother liquor, realizing the recycling of reagents. - The finally obtained FePO₄ powder can be used to prepare the original LFP cathode material, thereby realizing the effective recovery of valuable elements in the waste. In conclusion, this research provides an environmentally friendly and economically viable LFP battery recycling method, which helps to promote the sustainable development of the lithium - ion battery industry.

A fast and efficient method for selective extraction of lithium from spent lithium iron phosphate battery

Removal of impurity metals as phosphates from Lithium-ion battery leachates

High-efficiency leaching process for selective leaching of lithium from spent lithium iron phosphate

Study on selective recovery of lithium ions from lithium iron phosphate powder by electrochemical method

Process for recycle of spent lithium iron phosphate battery via a selective leaching-precipitation method

Selective leaching process for efficient and rapid recycling of spent lithium iron phosphate batteries

Selective recovery of lithium from lithium iron phosphate

Selective leaching of lithium from mixed spent lithium iron phosphate powder

A Facile Recovery Process for Cathodes from Spent Lithium Iron Phosphate Batteries by Using Oxalic Acid

Acid-Free and Selective Extraction of Lithium from Spent Lithium Iron Phosphate Batteries Via a Mechanochemically Induced Isomorphic Substitution

A method for recovering Li3PO4 from spent lithium iron phosphate cathode material through high-temperature activation

Selective recovery of lithium from spent lithium iron phosphate batteries using oxidation pressure sulfuric acid leaching system

Study on efficient and synergistic leaching of valuable metals from spent lithium iron phosphate using the phosphoric acid-oxalic acid system

A sustainable closed-loop method of selective oxidation leaching and regeneration for lithium iron phosphate cathode materials from spent batteries

Electrochemical selective lithium extraction and regeneration of spent lithium iron phosphate

A Facile Route for the Efficient Leaching, Recovery, and Regeneration of Lithium and Iron from Waste Lithium Iron Phosphate Cathode Materials

Highly selective and green recovery of lithium ions from lithium iron phosphate powders with ozone

Two Targets, One Strike: Efficient Recovery of Lithium and Simultaneous Removal of Impurities from Spent LFP Batteries Via Ferric Ions Assisted Air Oxidation Method

A green recyclable process for selective recovery of Li and Fe from spent lithium iron phosphate batteries by synergistic effect of deep eutectic solvent and oxygen

Ferrioxalate photolysis-assisted green recovery of valuable resources from spent lithium iron phosphate batteries

The priority leaching of lithium from spent LiFePO4 cathode without the oxidization