Abstract:At partial load, traditional automotive gasoline engines have high pumping losses due to the throttling of the intake charge for load control. Variable Valve Timing (VVT) and the introduction of externally cooled EGR could reduce the pumping losses but only with a very limited effect. On the other hand, in the medium to full load range, the engine cannot utilize a high compression ratio due to limitations in knocking. A variable displacement, variable compression ratio device which utilizes an asymmetric camshaft to realize the different closure times of the two intake valves is discussed in this paper. The large-scale change in the intake valve timing leads to the large-scale change in the effective cylinder volume at the intake valve closure, which realizes a variable cylinder volume and a variable effective compression ratio. The device is utilized to reduce the pumping losses and to increase the in-cylinder thermal efficiency at the same time. Engine dyno test results indicate that, in the low to medium load range, a later closure of the intake valve could reduce the effective cylinder volume, and the intake pressure could be significantly increased, and therefore pumping losses reduced. However, the reduced effective cylinder volume due to a later intake valve closure would lead to reduction in the effective compression ratio (ECR) and a drop in in-cylinder thermal efficiency. Therefore, there is a balance point between the pumping loss reduction and the drop in in-cylinder thermal efficiency. On the other side, in the medium to full load range, when avoiding knocking becomes the major controlling factor of the combustion phasing (degree of constant-volume combustion) and the effective expansion ratio (EER), too high of an effective compression ratio would lead to significant drop in the effective expansion ratio EER and also the in-cylinder thermal efficiency. Therefore, there exists a best compromise between the ECR and EER, and the best system would be one with a moderate ECR but an EER as high as possible. The quantitative equations which include both ECR and EER in the thermal efficiency calculations captured the above observations pretty well and can be utilized to optimize for the best compromise of IVC, EVO, ECR, EER and engine performances during the concept stage and/or the calibration stage of an engine.

Some investigations in design of low cost variable compression ratio two stroke petrol engine

Conceptual Study of Scroll-Type Rotary Gasoline Internal Combustion Engine

Evaluation of the Effect of Variable Compression Ratios Performance on Opposed Piston 2-Stroke Engine

Modification of 4-Stroke S.I. Engine to a Compressed Air Engine for a Light Utility Vehicle

Impact of Piston Geometry on Diesel Engine Performance, Emissions and Combustion

Development and Validation of a Variable Displacement Variable Compression Ratio Miller Cycle Technology on an Automotive Gasoline Engine

Low-pressure gasoline direct injection system development and emissions analysis for a reciprocating two-stroke engine

Experimental Investigations on the Effects of Low Compression Ratio in a Direct Injection Diesel Engine

Investigation into a stepped-piston engine solution for automotive range-extender vehicles and hybrid electric vehicles to meet future green transportation objectives

Novel strategies to overcome the limitations of a low compression ratio light duty diesel engine

CFD study and experimental investigation of piston geometry induced in-cylinder charge motion on LPG fuelled lean burn spark ignition engine

Combustion and Emission Enhancement of a Spark Ignition Two-Stroke Cycle Engine Utilizing Internal and External Exhaust Gas Recirculation Approach at Low-Load Operation

Opposed-Piston 2-Stroke Multi-Cylinder Engine Dynamometer Demonstration

Numerical optimization of supercharging and combustion on a two-stroke compression ignition aircraft engine

Investigation of gas exchange parameters of small two stroke engine correlated with hydrogen fuel supplement

Improving the design of an internal combustion engine with counter pistons

Experimental analysis of the system behavior of a two-stage variable compression ratio (VCR) system in fired SI-engine operation

Performance of SI Engine to Improve the Combustion Characteristics by Using Methanol Blended Petrol

Design and Simulation of an Electronically Controlled Single-Cylinder Diesel Engine to Lower Emissions

Performance Evaluation of a Single Cylinder Compressed Air Engine: An Experimental Study

STUDIES ON EFFECTS OF COMBUSTION CHAMBER GEOMETRY AND INJECTION PRESSURE ON BIODIESEL COMBUSTION