Abstract:A significant challenge in utilizing hydrogen in conventional internal combustion engines is achieving a balance between NOx emissions and brake power output. A lean premixed charge (Lambda ≈ 2.5) allows for efficient and stable combustion with minimal NOx emissions. However, this comes at the cost of reduced power density due to the higher air requirements of the thermodynamic process. While supercharging can mitigate this drawback, it introduces increased complexity, cost, and size. An intriguing alternative is the 2-stroke cycle, particularly in an opposed piston (OP) configuration. This study presents the virtual development of a single-cylinder 2-stroke OP engine with a total displacement of 0.95 L, designed to deliver 25 kW at 3000 rpm. Thanks to its compact size, high thermal efficiency, robustness, modularity, and low manufacturing cost, this engine is intended for use either as an industrial power unit or in combination with electric motors in hybrid vehicles. The overarching goal of this project is to demonstrate that internal combustion engines can offer a practical and cost-effective alternative to hydrogen fuel cells without significant penalties in terms of efficiency and pollutant emissions. The design of this novel engine started from scratch, and both 1D and 3D CFD simulations were employed, with particular focus on optimizing the cylinder's geometry and developing an efficient low-pressure injection system. The numerical methodology was based on state-of-the-art commercial codes, in line with established engineering practices. The numerical results indicated that the optimized engine configuration slightly surpasses the target performance, achieving 29 kW at 3000 rpm, while maintaining near-zero NOx emissions (<20 ppm) and high brake thermal efficiency (~40%) over a wide power range. Additionally, the cost of this engine is projected to be lower than an equivalent 4-stroke engine, due to fewer components (e.g., no cylinder head, poppet valves, or camshafts) and a lighter construction.

Investigation into a stepped-piston engine solution for automotive range-extender vehicles and hybrid electric vehicles to meet future green transportation objectives

Study of a Hybrid Pneumatic-Combustion Engine under Steady-State and Transient Conditions for Transport Application

Conceptual Study of Scroll-Type Rotary Gasoline Internal Combustion Engine

Low noise, vibration and harshness solutions for in-line three-cylinder range extender and hybrid electric vehicles

Low emission stepped piston engine for marine outboard motor application

Novel Three-Cylinder Engine Solutions Offering Low Noise Vibration and Harshness for Range-Extender and Hybrid Electric Vehicles

The Effect of Crankshaft Phasing and Port Timing Asymmetry on Opposed-Piston Engine Thermal Efficiency

Virtual Development of a Single-Cylinder Hydrogen Opposed Piston Engine

Development and Experimental Investigation of a Two-Stroke Opposed-Piston Free-Piston Engine

Opposed-Piston 2-Stroke Multi-Cylinder Engine Dynamometer Demonstration

Toward 2030 CO2 targets – high efficiency engine with gasoline compression ignition technology on a hybrid electric vehicle simulation

Investigation of gas exchange parameters of small two stroke engine correlated with hydrogen fuel supplement

Applications of Oxyhydrogen, Direct Water Injection, and Early-Intake Valve Closure Technologies on a Petrol Spark Ignition Engine—A Path towards Zero-Emission Hydrogen Internal Combustion Engines

Numerical investigations of combustion and emissions characteristics of a novel small scale opposed rotary piston engine fuelled with hydrogen at wide open throttle and stoichiometric conditions

Enhancing the Efficiency of Rotary Thermal Propulsion Systems

Optimization of Piston Bowl and Valve System in Compression Ignition Engine Fueled with Gasoline/diesel/polyoxymethylene Dimethyl Ethers for High Efficiency

Some investigations in design of low cost variable compression ratio two stroke petrol engine

Low-pressure gasoline direct injection system development and emissions analysis for a reciprocating two-stroke engine

Evaluation of the Effect of Variable Compression Ratios Performance on Opposed Piston 2-Stroke Engine

High-Performance Hydrogen-Fueled Internal Combustion Engines: Feasibility Study and Optimization via 1D-CFD Modeling

On the Use of a Hydrogen-Fueled Engine in a Hybrid Electric Vehicle