Abstract:Pneumatic submersible pump is a new type of drainage tool in farmland irrigation. The water supply at the pumping end of the submersible pump is sporadic with frequent no-load operation given the low water levels in most rural canals during summer. The change in water flow and pressure directly causes high turbine speed and thus leads to the runaway speed phenomenon, which seriously affects operational safety. A pneumatic control system based on metering-out control was proposed to prevent high turbine speed and minimize the consumption of the pneumatic submersible pump in irrigation and drainage. First, the pneumatic liquid level control system was designed to automatically adjust the pressure and flow of the submersible pump under no-load and load conditions. Second, the stability of the system was simulated by Advanced Modeling and Simulation Environment for Systems Engineering (AMESim), and the coupling relationship among turbine speed, inlet pressure, and flow rate was discussed with different metering-out flows. Finally, comparative experiments were conducted for verification. Simulation and experimental results show that under the no-load condition, when the inlet pressure reaches 0.2 Mpa, the rotating speed of the pneumatic submersible pump increases with the inlet pressure, and when the inlet pressure reaches 0.4 Mpa, the rotating speed of the pneumatic submersible pump remains approximately unchanged. When the outlet flow increases, the rotating speed of the pneumatic submersible pump also increases gradually; when the outlet flow is equal to the inlet flow, the rotating speed remains stable; when the inlet pressure is higher than 0.4 Mpa and the outflow flow is smaller than 18 m/h, the turbine speed can be less than 12000 r/min, which is lower than the critical runaway speed. Thus, the total power loss is not reduced. The control system solves the problem of runaway speed and realizes automatic speed control of the pneumatic submersible pump under the no-load condition. The proposed method provides wide application prospects and is suitable for discontinuous irrigation and drainage operation of rural canals.

Research on Starting Method for Deep Well Piston Pumps

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

New Distributing Mechanism for High Speed Single-Piston Axial Piston Pump

DEVELOPMENT OF SOLAR PUMPING SYSTEM BASED ON HIGH EFFICIENCY PUMPS

Design of New Hydraulic Pumping Unit with Electro-hydraulic Proportional Control

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

Design and experimental validation of a valve-distributed water radial piston pump

Design and Experimental Study on the Automatic Speed Control System of a Pneumatic Submersible Pump

Submersible direct-drive progressing cavity pump rodless lifting technology

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Experimental Study on Cavitation Characteristics of a Mixed-flow-pump During Starting Period

A New Design Method for the Transition Region of the Valve Plate for an Axial Piston Pump

Study On Transient Hydrodynamic Performance And Cavitation Characteristic Of High-Speed Mixed-Flow Pump

An Improved 3-Step Startup Method Based on Sensorless Vector Control of PMSM

Study on Control Performance of Digital Piston Pump Based on Virtual Prototype Technology

Analysis of working characteristics of five-cylinder reciprocating pump based on digital twin and development of monitoring platform

Comparative Experiments on a Self-priming Pump Delivering Water Medium During Rapid and Slow Starting Periods

Study on Internal Flow Characteristics and Pressure Pulsation Features of Pump-Turbine under the No-Load Startup Condition with Different Heads

Research on the Transient Hydraulic Characteristics of Multistage Centrifugal Pump During Start-Up Process

Design and Simulation of Linear Motor Pumping Unit

Development and application of an integrated system of dewatering and recharge for the deep foundation pit