Abstract:High-speed, pressure-compensated variable displacement piston pumps are widely used in aircraft hydraulic systems for their high power density. The swash plate is controlled by the pressure-compensated valve, which uses pressure feedback so that the instantaneous output flow of the pump is exactly enough to maintain a presetting pressure. The oscillation of the swash plate is one of the major excitation sources in the high-speed piston pump, which may cause lower efficiency, shorter service life, and even serious damage. This paper presents an improved model to investigate the influence of the variable displacement mechanism on the swash plate oscillation and introduces some feasible ways to reduce oscillation of the swash plate. Most of the variable structural parameters of the variable displacement mechanism are taken into consideration, and their influences on swash plate oscillation are discussed in detail. The influence of the load pipe on the oscillation of the swash plate is considered in the improved model. A test rig is built and similarities between the experiments and simulated results prove that the simulation model can effectively predict the variable displacement mechanism state. The simulation results show that increasing the volume of the outlet chamber, the spring stiffness of the control valve, the action area of the actuator piston, and offset distance of the actuator piston can significantly reduce the oscillation amplitude of the swash plate. Furthermore, reducing the diameter of the control valve spool and the dead volume of the actuator piston chamber can also have a positive effect on oscillation amplitude reduction.

Design and Simulation of Linear Motor Pumping Unit

Study on Characteristic Matching and Design of Semi-Direct Drive PMSM of Beam Pumping Unit Based on Indicator Diagram

Flow characteristics simulation and low-noise design of fuel piston pump

Design, Modeling, and Pressure Control of a 300-Kw-class Hydraulic Pump/motor Loading System with Energy Regeneration

Design of New Hydraulic Pumping Unit with Electro-hydraulic Proportional Control

Modeling and Optimization for Submersible Pump Tubular Linear Motor Based on Dynamic Load Analysis

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

The Design and Analysis of a Hydro-Pneumatic Energy Storage Closed-Circuit Pump Control System with a Four-Chamber Cylinder

Kinematic and Dynamic Analysis of Eccentric Balanced Positive Torque Pumping Unit

Structural Design of a Cross Wobble Plate Driving Axial Piston Pump Based on ADAMS and AMESim Co-simulation

Modeling and Simulation on Axial Piston Pump Based on Virtual Prototype Technology

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

A Theoretical Dynamic Model to Study the Vibration Response Characteristics of an Axial Piston Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Design of a New Energy-saving Hydraulic Pumping Unit with Variable Speed Control and Closed Oil Circuits

Design and Optimization of Self-Compensation Oil Distributor for Hydraulic Motors

Modeling of Pneumatic Dual Reciprocating Bellows Pump with Flexible Linkage

Designing an Improved Controller for a Pump Direct Driven Electro-Hydraulic System Using a Nonlinear Flow Mapping

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Modeling and Analysis of the Tilt Behavior of the Cylinder Block in a High-Speed Axial Piston Pump

Research on Multi-Objective Optimization of Low Pulsation Unloading Damping Groove of Axial Piston Pump