Abstract:An accurate calculation of the indicator diagram of a pumping unit is the key factor in analyzing the performance of an oilfield production and operation and in preparing and optimizing an oilfield development plan. Aiming at the problems of the poor stability of the conventional load-displacement sensor method and the wave equation method, owing to the influence of an alternating load on the force sensor and the difficulty in measuring the crank angle using the electrical parameter method, a new soft sensing method employing the input electrical parameters of the motor and the beam inclination has been proposed to obtain the indicator diagram. At first, this method is established based on the beam angle of the pumping unit, which is easily measured using the suspension point displacement mathematics calculation model and the torque factor. Subsequently, the electric motor input parameters, the parameters of the four-bar linkage, and the relationship between the polished rod load have been established. Finally, the motor and the beam angle of the measured electrical parameters have been substituted into the calculation of the suspension point displacement and load value and pull in accordance with the guidelines to eliminate the singularity mutation values. After processing the measured data through a Butterworth filter, the indicator diagram is obtained. The results of the engineering experiment and application show that the average relative error of the method is less than 3.95%, and the maximum relative error remains within 2% for 6 months, which verifies the stability of the soft sensing method.

Study on Characteristic Matching and Design of Semi-Direct Drive PMSM of Beam Pumping Unit Based on Indicator Diagram

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

An Investigation in Performance of a Variable-Speed-Displacement Pump-Controlled Motor System

Optimization Design of an Interior Permanent-Magnet Synchronous Machine for a Hybrid Hydraulic Excavator

Modeling and Realization of Multiphase Permanent Magnet Synchronous Motor Variable Speed System

Low Vibration and Noise Design of Integrated Permanent Magnet Synchronous Motor (PMSM)

Modeling and Optimization for Submersible Pump Tubular Linear Motor Based on Dynamic Load Analysis

Preparation Analysis of the Overall Characteristics for High Power PMSM with Multi Phase Units

Design and analysis of an axial flux permanent magnet motor for the direct drive radial piston pump

Design and Simulation of Linear Motor Pumping Unit

Magnetic Field and Force Characteristic of Disc-Type Permanent Magnet Motor for Novel Pumping Unit

Optimized Design of High Torque Density Permanent Magnet Synchronous Motor with Halbach Magnet

An Optimizing Method of Complex PI Controller for Permanent Magnet Synchronous Motor in Magnetic Saturation

Research on the Soft-Sensing Method of Indicator Diagram of Beam Pumping Unit

Design and Optimization of Synchronous Motor Using PM Halbach Arrays for Rim-Driven Counter-Rotating Pump

Design of A Novel Permanent Magnet Linear Synchronous Motor with Segmented Armature Core for Ropeless Lifter

Design and Function Analysis of Multiphase PM Bearingless Motor with Single Set of Windings

Design of direct-drive air compressor drived by permanent magnet brushless DC motor

Dynamic Modeling of Surface-Mounted Permanent Magnet Motors Considering Saturation

Research on Electromagnetic and Vibration Characteristics of Dynamic Eccentric PMSM Based on Signal Demodulation

Development of a Low-speed High-efficiency PMSM and Its Drive System for Electric Windlass and Mooring Winch