Abstract:Pollution accumulation and the wetting of the contamination layer subsequently formed on the insulator surface are two important factors influencing the pollution flashover of the insulators. To investigate the wetting of contamination layer on the insulator surface, the saturated water absorption of contamination layer on glass specimens was measured in a fog room and the experimental results were analyzed. Under saturated moisture condition, there is a fixed ratio of conductive particles to water molecules in the salt fog that is generated by an ultrasonic humidifier. When the salt fog particles were deposited on the specimens, the surface conductivity of the contamination layer will increase linearly with the salt fog mass deposited. In this paper, a new method was proposed to measure the saturated water absorption of the contamination layer based on the surface conductivity. Based on this method, the influence of non-soluble deposit density (NSDD) and the inclination angle of specimen on the saturated water absorption of the contamination layers were analyzed. The experimental results showed that the saturated water absorption of contamination layer gradually decreased with the increase of inclination angle. With the same NSDD, the saturated water absorption of the contamination layer at the bottom surface of the specimen was less than that of the top surface. The increase of NSDD would lead to an increase of saturated water absorption of the contamination layer under vertical arrangement.

Method analyses of artifieial test for insulator water migrating

Investigation on Wetting Process of Polluted Composite Insulators

Research on Analysis Method of Equivalence Between Natural Polluted Insulators and Artificial Contaminated Insulators

Description Method Ⅲ—for Unobvious Hydrophobic State of Composite Insulators Usability of Droplet Area Method

THE HYDROPHOBICITY MIGRATING STABILITY OF THE EXTERNAL INSULATING MATERIAL OF COMPOSITE INSULATOR

Description Method Ⅱ for Unobvious Hydrophobic State of Composite Insulators——Uncertainty of Hydrophobic Degree by Spray Grading Method

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Analysis on Wetting and Conductive Properties of Natural Polluted Insulators

STUDY OF THE POLLUTION PERFORMANCE OF COMPOSITE INSULATOR IN HIGH ALTITUDE AREA

A Forecast Method for Leakage Current of Contaminated Insulator Under Saturated Moist

Study on Method and Device Used for Evaluating the Contamination Condition on the Surface of Composite Insulator

Wetting Characteristics of Contaminated Porcelain and Glass Insulators

Discussion on Contaminating Method for High Temperature Vulcanizing Silicone Rubber Samples

Aging Characteristics of Composite Insulators Based on Hydrophobicity Transfer Test

Volatility of Hydrophobicity on the Polluted Surface During Hydrophobicity Transfer

Hydrophobicity Transfer Feature Comparison for HTV Silicone Rubber Polluted by Different Kaolin

Mathematical Analysis on Service Status of Silastic Composite Insulators

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Effect of Uneven Hydrophobicity on Anti-pollution Flashover Performance of Line Insulators

Instruments and Method for Measuring Partial Surface Conductivity

Artificial pollution test and pollution performance of composite insulators