Abstract:Moisture plays a major role in the aging phenomena of high temperature vulcanizing silicone rubber material, which is always used as composite insulator sheds and sheath. In order to obtain an appropriate model to describe the water molecule diffusion process into silicone rubber, as well as the diffusion characteristics of this process, the solid state nuclear magnetic resonance (NMR) was conducted to investigate the existence state of water molecule in silicone rubber. The gravimetric method was also employed to obtain the weight gain curves caused by the water molecule diffusion. The study shows that water molecules had two different states in silicone rubber, one is “free” state and the other one is “bound” state. By combining the results of NMR analysis and gravimetric method analysis, the model of water diffusion into silicone rubber was suggested, i.e., this diffusion process could be explained quantitatively by a Non-Fick diffusion model, Langmuir diffusion model, instead of the classical Fick diffusion model. In addition, the paper studied the influence factors of the diffusion process of water molecules into silicone rubber; the study indicated that the amount of free state water increased with temperature increasing and the amount of bound state water decreased with temperature increasing. The effect of temperature on the diffusion coefficient is in accordance with the classical Arrhenius equation. The increasing the amount of the Alumina Tri-hydrate(ATH) content in silicone rubber had the effect of increasing the amount of bound state water, however, the amount of free state water is relative insensitive to the ATH content.

Discussion on Contaminating Method for High Temperature Vulcanizing Silicone Rubber Samples

Effect of Plasma Jet on Hydrophobicity of Contaminated High Temperature Vulcanization Silicone Rubber

Hydrophobicity Transfer Feature Comparison for HTV Silicone Rubber Polluted by Different Kaolin

Volatility of Hydrophobicity on the Polluted Surface During Hydrophobicity Transfer

STUDY OF IMPROVING PROPERTIES OF ROOM TEMPERATURE VULCANIZING SILICONE RUBBER

Investigation on Wetting Process of Polluted Composite Insulators

Analysis of Operating Performance of RTV Coating Used in Areas With Humid Climate

Description Method Ⅲ—for Unobvious Hydrophobic State of Composite Insulators Usability of Droplet Area Method

Influence of the Plasma Jet Parameters on the Hydrophobicity Transfer Rate of Contaminated Silicone Rubber

Influence of High Conductivity Fog on the Hydrophobicity of Composite Insulator

Method analyses of artifieial test for insulator water migrating

Description Method Ⅰfor Unobvious Hydrophobic State of Composite Insulators——Usability of Contact Angle Method

Description Method Ⅱ for Unobvious Hydrophobic State of Composite Insulators——Uncertainty of Hydrophobic Degree by Spray Grading Method

A Study on the Hydrophobicity Migraton of the Room Temperature Vulcanized Silicone Rubber Coating

Study on the Relationship Between the Hydrophobicity of RTV on Insulator Surface and the UV Imaging Results of the Discharge

Investigation on Hydrophobicity Transfer Property of Silicone Rubber under Heavy Contamination

Influence of Ambient Humidity on Hydrophobicity Transfer of Silicone Rubber Material

Study on discharge along polluted surface with silicone coating

Investigation on Water Diffusion Property Into HTV Silicone Rubber

Test & Research of Water Absorption & Water Permeation of Composite Insulator HTV Silicone Rubber Material

Improvement of Interface Adhesion Property of Contaminated Rtv Silicone Rubber by Plasma Jet