Abstract:The measurements of gravity have been widely applied to earthquake monitoring, resource exploration and identification of natural voids. Traditional gravimeters, restricted by the exorbitant price and bulk, are hardly to be utilized in newly developed applications such as AUV-borne gravimetry and the multi-pixels gravimetry. Fortunately, this is changing with the development of portable MEMS gravimeters.Here, we have already developed a relative MEMS gravimeter with a quasi-zero stiffness spring-mass system and an arrayed area-changed capacitor for displacement transducing and actuating. This quasi-zero stiffness spring-mass system transfers the acceleration variation to the displacement of the proof-mass with high sensitivity. The displacement is then detected by the arrayed area-changed capacitor. The spring-mass system was installed inside a vacuum chamber for reducing the thermal noise and environmental disturbances. However, the response time of the gravimeter was enlarged when operating in open-loop mode dues to the decreased air damping. Therefore, a force-balance system is utilized in a MEMS gravimeter to improve the response time and the measurement range. This paper proposes an area-changed capacitors for transducing the displacement and balancing the inertial force on the proof-mass. As no additional structures are required on the MEMS chip, the design of the force-balance system is beneficial to simplifying the fabricating process and avoiding additional noise sources.We calibrated our MEMS gravimeter statically in our cave lab. After linear correction of the drift, the output of the MEMS agrees well with the theoretical earth tide with a coefficient of association of 0.92. The self-noise is evaluated to be 1 μGal/√Hz, which is one of the most sensitive MEMS-based gravimeter reported. In addition, the response time of the MEMS gravimeter was calibrated to be 0.2 s in close-loop mode, which is 2000 times faster than that in open-loop mode. This will promote improved accessibility of mobile gravity measurements at an affordable cost.

Novel Capacitive Sensing System Design of A Microelectromechanical Systems Accelerometer for Gravity Measurement Applications

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

A MEMS Micro-g Capacitive Accelerometer Based on Through-Silicon-Wafer-Etching Process

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

Novel Area-Changed Capacitive Methods for Simultaneous Displacement Transducing and Force Balance in a Nano-g MEMS Accelerometer

Design and Modification of a High-Resolution Optical Interferometer Accelerometer

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass

Design And Fabrication Of A Slanted-Beam Mems Accelerometer

Performance of a Sensitive Micromachined Accelerometer with an Electrostatically Suspended Proof Mass

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

A Force-Balance MEMS Gravimeter with Area-Changed Capacitors for Transducing and Actuating

An Optical Interferometry Based MEMS Accelerometer Applicable to Seismic-Grade Measurement

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

A Novel Sandwich Capacitive Accelerometer with A Double-Sided 16-Beam-mass Structure

Design, Manufacture And Test Of Novel Mems Piezoresistive Accelerometer For High G Application

Design of a Novel Low Cross-Axis Sensitivity Micro-Gravity Sandwich Capacitance Accelerometer.

High-resolution MEMS inertial sensor combining large-displacement buckling behaviour with integrated capacitive readout

A Seismic-Grade Optical MEMS Accelerometer with Force Feedback Control

A Subnano-g Electrostatic Force-Rebalanced Flexure Accelerometer for Gravity Gradient Instruments.