Abstract:Diesel hydrogenation unit is an important equipment for processing inferior oil in petroleum refining enterprises. Among them, the U-tube heat exchanger has been in high temperature and corrosive environment containing chlorine for a long time. Serious problem of tube bundle corrosion failure caused by ammonium chloride salt deposit. Anatomy of the diesel hydrogenation heat exchanger showed that the leakage part mainly appeared in the outermost bundle of the heat exchanger tube near the exit section, and the local area showed a large area of gully damage. Metallographic and XRD results show that the failure tube bundle material does not have manufacturing defects, and the corrosion location scale contains NH4Cl and iron oxides. The process flow analysis based on PR-NRTL model showed that the heat exchanger was in the NH4Cl crystallization temperature range, and the crystallization temperature increased with the increase of N and Cl contents in raw materials. Fluid simulation analysis of inlet tube box and single U-tube is carried out by using component transport equation and condensation model. Computational fluid dynamics (CFD) results indicate that there is a low velocity zone with high volume fraction of gas phase in the tube box. The higher gas volume fraction results in the formation of more NH4Cl particles into the U-tube bundle during heat transfer cooling. With the decrease of temperature, liquid water content in U-tube increases gradually and mainly distributes at both sides and bottom of tube bundle. The gas phase gradually fills the top of the tube bundle, and the oil and gas stratification becomes more obvious. The mass transfer rate and corrosion rate were the highest at the bottom and both sides of the tube bundle. With the temperature decreases, the NH4Cl particles generated in the tube continue to increase. The particles were deposited at 2000–3000 mm near the outlet section of the U-tube tube. NH4Cl particles absorbed liquid water, resulting in under-deposit corrosion of the tube bundle, and eventually led to the thinning and leakage of the heat exchanger tube bundle.

Experimental study on crystal deposition mechanism of ammonium chloride particles on the surface of heat exchange tube

Effect of NH 4 Cl fouling on heat transfer process of heat exchange tube under forced convection condition

Analysis of Multiphase Flow and Heat and Mass Transfer for Ammonium Chloride Crystallization of the High-Pressure Heat Exchanger in Hydrogenation Unit

Study on the effects of the surface temperature on the formation of ammonium chloride and fly ash deposits

Crystallization Behavior of Ammonium Chloride in High-Pressure Heat Exchanger of Hydrotreating Unit

Failure analysis of ammonium chloride salt coagulation corrosion of U-tube heat exchanger in diesel hydrogenation unit

Modelling of initial deposition of biomass ash particles on walls of superheater tubes

Crystallization Fouling on Different Surfaces under Static and Dynamic Experiments

Visualization study on NaCl crystal behavior on foamed ceramic surfaces used as hot stream channel of air-gap diffusion distillation

Experimental Research on Anti-fouling of Heat Exchanger

Heat Transfer Study from a Salty Droplet Film on a Horizontal Tube in Mechanical Vapor Recompression Crystallization System

Impact of Tube Surface Properties on Crystallization Fouling in Falling Film Evaporators for Seawater Desalination

A Study on Ammonium Chloride Dendrite Tip Kinetics: The Importance of the Solid–Liquid Density Change and Interfacial Kinetics

Experimental investigation of surface roughness/wettability pattern effect on crystallization fouling over falling-film flow

Experimental study on impact patterns and dynamics characteristics of NaCl water droplet with different concentrations on heated surface

Ammonia thermal decomposition on quartz and stainless steel walls

Influence of an Axial-Electromagnetic Field Treatment Device with a Solenoid Structure on Crystallization Fouling on the Tube Side of a Shell-and-Tube Heat Exchanger

Effect of carbonized ammonia constituent on the crystallization process

Numerical simulation of solidification of boiler molten ash impinging on vertical wall based on Smoothed Particle Hydrodynamics method

Falling film boiling of a salt droplet on a slightly inclined plane: Flow, heat transfer, and crystallization

Molecular dynamics simulation on crystal morphology of NH4ClO4