Abstract:Spray cooling features with high heat flux and good temperature control ability, which has been widely used in industrial environments such as electronic devices and nuclear power plants. In this study, the transient process of droplet-wall collision under film and transition boiling conditions has been investigated experimentally via the high-speed shadowgraph imaging and state-of-the-art image processing techniques. Based on intensive test conditions, the impact morphology, number, size, trajectory, ejecting angle and velocity of secondary droplets are presented and analyzed comprehensively. In experiments, distilled water was the test fluid, with initial droplets at 3 ± 0.03 mm. Droplet collision velocity was calculated based on the center distance in two pre-collision frames. The Weber number changes from 15.4 to 104.2, while the wall temperature varies from 307.6 °C to 511.8 °C. The observed collision phenomena can be divided into four types, including rebound, rebound with secondary atomization, breakup with secondary atomization, and breakup. An Improved Cascade Gaussian Fitting method (ICGF), which performs well in the dense and mutually occlusive areas, is adopted for particle identification. The statistical results show that the secondary droplet diameter mainly distributes in the range of 0.02 mm to 0.2 mm under different Weber numbers. Under similar wall temperature conditions, the number of secondary droplets and the average diameter of secondary droplets increase with Weber number. Moreover, the separation mass ratio increased from 0.18 % to 2.29 %. Specifically, it is found that the amount and size of secondary droplets decrease significantly when the boiling mode transfers from transition to film. Based on the time-resolved shadowgraph images, a four-frame optimal estimation particle tracking algorithm is used to obtain the two-dimensional trajectory of the secondary droplets. The measured velocity distributes in the range of 0.3 m/s-4.0 m/s, mainly concentrating in the range of 0.5 m/s-2.0 m/s. The number and size variation with time is also analyzed, which indicates most of the secondary droplets are generated due to the strong instability in the transition boiling states.

Falling film boiling of a salt droplet on a slightly inclined plane: Flow, heat transfer, and crystallization

Visualization and quantitative study on film boiling heat transfer of a salt droplet on the hydrophobic substrate

Droplet Evaporation to Boiling in Van Der Waals Fluid

Evaporation with Salt Crystallization in Capillaries of Different Cross Sections

Experimental investigation of surface roughness/wettability pattern effect on crystallization fouling over falling-film flow

Heat Transfer Study from a Salty Droplet Film on a Horizontal Tube in Mechanical Vapor Recompression Crystallization System

Droplet boiling on heated surfaces with various wettabilities

Dropwise Condensation Heat Transfer on Nanostructured Superhydrophobic Surfaces with Different Inclinations and Surface Subcoolings

Evaporation and crystallization process for sessile saline droplets during depressurization

A mechanism for the bubble formation during evaporative crystallization of saline droplets below boiling point

Falling Film Flow and Heat Transfer of Cryogenic Liquid Oxygen on Different Structural Surfaces

Effects of chemical and geometric micro-structures on crystallization of surface droplets during solvent exchange

Experimental study on impact patterns and dynamics characteristics of NaCl water droplet with different concentrations on heated surface

Falling film flow and heat transfer on a horizontal tube under the shearing of vertical vapor

Quantifying Salt Crystallization Impact on Evaporation Dynamics From Porous Surfaces

Dynamic characteristics of droplet impact on heated surfaces near Leidenfrost temperature

Droplet Impact on Superheated Micro-Structured Surfaces

Boiling transitions during droplet contact on superheated nano/micro-structured surfaces

Evaporation of Saline Droplets on a Superhydrophobic Substrate: Formation of Crystal Shell and "Legs"

Elevating Leidenfrost temperature by orderly droplet stream impingement boiling

Wall Heat Flux Partitioning During Subcooled Flow Boiling of NaCl Solutions and Pure Water