Abstract:High inrush current severely threats the safe operation of the power system and transformers, which may lead to mal-operation of overcurrent protection device, internal short-circuit fault in transformers. Phase-controlled switching technology is an alternative method to reduce inrush current effectively by controlling the front-mounted circuit breaker (CB) to break or make at the predetermined phase angles of current or voltage. In this paper, a new simplified phase-controlled switching strategy is proposed for three-phase unloaded transformer with Y-connected windings in the primary side, which can limit the inrush current under 46.7% of the captured maximum inrush current. Meanwhile, this strategy is independent on the residual fluxes in the iron cores. The optimal making angle is obtained by theoretical analysis based on an equivalent circuit model of unloaded transformer. The comparison of the proposed method and the random switching approach is also presented with considering residual flux. A simulation model is established to calculate the amplitudes of inrush currents against various residual fluxes when using the proposed phase-controlled switching strategy and random switching method. The simulation results show that the proposed strategy can limit the inrush current under a low value. A test platform with high and low voltage instruments is built and some measurements are carried out. The experimental results are in good agreement with the theoretical analysis and simulation results, which verifies the effectiveness and practicability of the proposed strategy.

A Novel Strategy for Reducing Inrush Current of Three-Phase Transformer Considering Residual Flux.

A Simplified Phase-Controlled Switching Strategy for Inrush Current Reduction

Three-Phase Transformer Inrush Current Reduction Strategy Based on Prefluxing and Controlled Switching

Research of Controlled Switching Strategy to Restrain Inrush Current During the Energisation of Converter Transformer

Elimination of Transformer Inrush Current by Three-Phase Linkage Circuit Breakers.

Residual Flux Estimation Method for Three-Phase Transformers Without Zero-Sequence Circuit on the Switch-off Side

Study on Inrush Current Restraining Technology when Energizing No-load Transformer

Controlled Vacuum Circuit Breaker For Transformer Inrush Current Minimization

An inrush current mitigation approach of The output transformer for inverter

A method to eliminate the magnetizing inrush current of energized transformers

Novel Inrush Current Restraining Method for Transformers of Shipboard Power System

The Inrush Current Analysis and Restraining Method of Energizing No-Load Transformer

Research on Phase-controlled Technology of Inrush Current Based on Closing Resistance

Laboratory Investigation on Phase Selection Closing Approach for Suppression of Inrush Current

A Novel Scheme Based on Flux Restraint Theory Used in Distinguishing Inrush Currents for UHV Transformers

A Novel Magnetizing Inrush Current Suppressor of Energized Transformers

An Inrush Current Suppression Strategy for Fast Voltage Recovery

A NEW METHOD TO IDENTIFY INRUSH CURRENT BY PHASOR COMPARISON

Mitigating the Inrush Current of V/V Transformers Using Railway Conditioners

INVESTIGATIONS ON SWITCHING IDLE POWER TRANSFORMER WITH PHYSING VACUUM CIRCUIT BREAKERS

Inrush Current Reduction Strategy for a Three-Phase Dy Transformer Based on Pre-Magnetization of the Columns and Controlled Switching