Abstract:Abstract Given the “carbon neutralization and carbon peak” policy, enhancing the low voltage ride-through (LVRT) capability of wind farms has become a current demand to ensure the safe and stable operation of power systems in the context of a possible severe threat of large-scale disconnection caused by wind farms. Currently, research on the LVRT of wind farms mainly focuses on suppressing rotor current and providing reactive current support, while the impact of active current output on LVRT performance has not been thoroughly discussed. This paper studies and reveals the relationship between the limit of reactive current output and the depth of voltage drop during LVRT for doubly-fed induction generator (DFIG) based wind farms. Specifically, the reactive current output limit of the grid-side converter is independent of the depth of voltage drop, and its limit is the maximum current allowed by the converter, while the reactive current output limit of the DFIG stator is a linear function of the depth of voltage drop. An optimized scheme for allocating reactive current among the STATCOM, DFIG stator, and grid-side converter is proposed. The scheme maximizes the output of active current while satisfying the standard requirements for reactive current output. Compared to traditional schemes, the proposed LVRT optimization strategy can output more active power during the LVRT period, effectively suppressing the rate of rotor speed increase, and improving the LVRT performance and fault recovery capability of wind farms. Simulation results verify the effectiveness of the proposed scheme.

A transformer inrush reduction technique for low-voltage ride-through operation of renewable converters

An Inrush Current Mitigation Method for the Grid-Connected Converters in the Low-Voltage Ride-Through Operation

A Low-Voltage Ride-Through Method with Transformer Flux Compensation Capability of Renewable Power Grid-Side Converters

Low Voltage Ride-Through of Two-Stage Grid-Connected Photovoltaic Systems Through the Inherent Linear Power-Voltage Characteristic

A Low-Voltage Ride-Through Technique for Grid-Connected Converters with Reduced Power Transistors Stress

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

A Flexible Low-Voltage Ride-Through Operation for the Distributed Generation Converters

An Inrush Current Reduction Technique for Multiple Inverter-Fed Transformers

A Low-Voltage Ride-Through Technique for Grid-Connected Converters of Distributed Energy Resources

Low Voltage Ride-Through of Single-Phase Transformerless Photovoltaic Inverters

A Transformer Inrush Mitigation Method for Series Voltage Sag Compensators

A Review on Low Voltage Ride-through Technologies and Prospect for DFIG Wind Turbines

A Reactive Current Injection Technique for Renewable Energy Converters in Low Voltage Ride-Through Operations

An Inrush Mitigation Technique of Load Transformers for the Series Voltage Sag Compensator

High-voltage Ride-Through Strategy for Wind Turbine with Fully-Rated Converter Based on Current Operating Range

An Operation Strategy for the Hybrid Distribution Transformer to Suppress the Magnetizing Inrush Current

A Low Voltage Ride Through Control Strategy for PMSG Based on Electromechanical Energy Storage

Potential and Challenges in LVRT for Grid-Forming Wind Turbines Brought by the Emergence of New Power Modules with Enhanced Short-Circuit Current

Analysis of low voltage ride-through capability and optimal control strategy of doubly-fed wind farms under symmetrical fault

An Inrush Current Mitigation Technique for the Line-Interactive Uninterruptible Power Supply Systems

Low voltage ride through control strategy for high-power grid-connected photovoltaic inverter