Abstract:The system voltage may be negatively impacted by the transformer’s energisation which draws a large value of magnetising inrush current for a few seconds. During the transformer’s energisation process, it experiences an unexpected saturation. When the transformer is saturated, the growth of magnetising inrush current, sympathetic inrush current and voltage sags are a few issues that are appear. Numerous variables that affect the inrush current and the resulting voltage sags were taken into consideration. This is due to the fact that the energisation of a large power transformer may result in a high voltage sag which relies on a value of parameters, including the duration of the circuit breaker closing time. One of the most essential objectives for power quality is the research of voltage sags that appear in a network. The goal of this project is to investigate sympathetic and inrush currents as well as to assess the voltage sag that occurs during transformer energisation and how severe it is. In this paper, the voltage sags are analysed by modelling 100kVA, 11kV/415V of wye-delta of single line (circles) transformer and using PSCAD software. It is expected to observe the magnitude, the duration and the percentage of voltage sags in order to make a comparison result between single connected transformer, two parallel-connected transformers and three parallel-connected transformers. To predict the severity of the sympathetic inrush current, the effects of voltage sags and their assessment is developed. As a result, it has been shown that the more energisation of the transformers, the peak of inrush current increases causing the higher magnitude and the longer duration of voltage sags. In conclusion, the voltage sags also become severe and persists for a longer duration when the number of transformers in operation are increased.

A Transformer Inrush Mitigation Method for Series Voltage Sag Compensators

An Inrush Mitigation Technique of Load Transformers for the Series Voltage Sag Compensator

Solutions for Keeping Frequency Converter Running from Voltage Sag

An Inrush Current Mitigation Technique for the Line-Interactive Uninterruptible Power Supply Systems

Design and Implementation of a Series Voltage Sag Compensator under Practical Utility Conditions

Assessment and Mitigation Studies of Voltage Sags during Sympathetic Inrush Current

Control Methods to Improve Virtual Power Angle Transient Stability of Droop-Controlled Inverters

An Inrush Current Mitigation Method for the Grid-Connected Converters in the Low-Voltage Ride-Through Operation

Risk Assessment of Post-Fault Temporary Overvoltage Using Generalized Short-Circuit Ratio

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

UPS flux compensation techniques for transformer inrush reduction

A transformer inrush reduction technique for low-voltage ride-through operation of renewable converters

An In-rush Current Suppression Technique for the Solid-State Transfer Switch System

Development of Voltage Sag Ride-Through Capability for the Auxiliary Front-End Converter

Design of an Impulse Commutation Bridge for the Solid-State Transfer Switch

An Inrush Current Reduction Technique for Multiple Inverter-Fed Transformers

Mitigating the Inrush Current of V/V Transformers Using Railway Conditioners

Mitigation on Sympathetic Inrush Current Phenomena between Parallel-Connected Transformers using PSCAD/EMTDC

Flux Estimation Techniques for Inrush Current Mitigation of Line-Interactive UPS Systems

A Series Voltage Compensator Based on Thyristor-Controlled Transformer

Overvoltage Suppression Under Commutation Failure Based on Improved Voltage-Dependent Current Order Limiter Control Strategy