Abstract:The electrical distribution system is crucial for the utility grid to transmit power from generators to consumers. Considering the intricate structure of distribution systems and their significant role in power networks, establishing a robust fault classification and location scheme is vital. Due to ageing, distribution systems are often prone to faults from factors like poor operational conditions and wear and tear. The line faulting rate and the pertinent restoration epochs influence the frequency and duration of power disruptions. Thus, precisely locating the fault section is essential to minimize power restoration timeframes. This paper presents a hybrid fault classification and location technique in a combined continuous overhead and underground distribution line. A simulation of the hybrid model was designed in Simulink for an 11 kV combined continuous overhead and underground electrical distribution line, considering short circuit faults as they are the most predominant and cause massive damage in distributed systems. The proposed technique first classifies the fault using Discrete Wavelet Transforms (DWT) and Multi-layer Perceptron-Artificial Neural Networks (MLP-ANN). Next, the impedance and Adaptive Neuro-Fuzzy System (ANFIS) based technique is employed for fault location. At a sample rate of 50 kHz, the DWT was applied to current signals and the coefficients used for ANN training, while phase impedance values were used as input to the ANFIS for training. The simulation results showed accuracy of 96.6% for fault classification and 99.17% for fault location. The developed models can significantly enhance fault location for speedier outage resolution by promptly repairing the affected distribution lines.

Locating Double-Line-To-Ground Faults Using Hybrid Current Profile Approach

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Locating of Multi-Phase Faults of Ungrounded Distribution System

Fault Location Algorithm for HV Transmission Lines Immune to Saturation of Current Transformers

Active Fault-Locating Scheme for Hybrid Distribution Line Based on Mutation of Aerial-Mode Injected Pulse

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

Fault Line Identification Of Single Line To Ground Fault For Non-Effectively Grounded Distribution Networks With Double-Circuit Lines

Location of Asymmetric Ground Fault Using Virtual Injected Current Ratio and Two-stage Recovery Strategy in Distribution Networks

Fault Location Algorithm Based on Characteristic- Harmonic Measured Impedance for HVdc Grounding Electrode Lines

A Fault Location Algorithm for Multi-Section Combined Transmission Lines Considering Unsynchronized Sampling

Fault Location Method for Distribution Network Based on Synchronous Measurement

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

A two-phase electric quantity-based fault location algorithm for power distribution systems

A Hybrid Technique for Fault Classification and Location in a Jointed Overhead-Underground Distribution Line

A ground fault location algorithm in double‐circuit transmission lines with T‐off connection to an industrial microgrid by using current and voltage phasors information of a single terminal

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

Line Fault Analysis of Ungrounded Distribution Systems

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

Novel location algorithm for single-line-to-ground faults in transmission line with distributed parameters

A novel fault location method for hybrid lines based on traveling wave