Abstract:In the past decades, Zirconia (ZrO2) has emerged as a promising technical ceramic, both as high temperature structural material and electrolyte for fuel cells, etc. The traditional synthesis of ZrO2 with spark plasma sintering (SPS) usually requires a sintering temperature as high as 1200 °C. General interest in lowering the sintering temperature to reduce energy consumption and thermal stresses has led to research on two promising routes – cold sintering via temperature-dependent chemical reactivity and sintering aids, which facilitates mass transport and improves densification. Here we combine both by developing a single-step sintering process benefitting from both water vapor through the in-situ conversion of Zr(OH)4 to ZrO2 and liquid phase Bi2O3 as a sintering aid. The resultant ZrO2 has a relative density above 80% with a sintering temperature as low as 900 °C, significantly higher than that of ZrO2 without sintering aids, which had a relative density of 54%, both sintered at 50 MPa. The dependence of porosity of sintered samples as a function of sintering pressure (range: 50 MPa–300 MPa) and temperature (range 400 °C–1200 °C) is mapped out as guidance for further material property design. A linear relationship between hardness and relative density was found, with a maximal hardness of 6.6 GPa achieved in samples with 30% porosity. In addition to sintered density, phase stabilization of tetragonal ZrO2 is enhanced at sintering temperature of 900 °C with water vapor and Bi2O3, respectively.

Constrained Sintering of A Low-Fire, Polycrystalline Bi-2(Zn1/3nb2/3)(2)O-7 Dielectric

Constrained Sintering of Bi 2 O 3 ‐doped ZnO

Sintering behavior and mechanism of Bi‐Zn‐Nb‐O microwave dielectric ceramics

Chemical Synthesis of Cubic Bismuth Zinc Niobate Ceramic and Its Dielectric Properties

Sintering Behavior and Dielectric Property of BST-BZN Composite Ceramics

Low-Fire Processing of ZrO<sub>2</sub>-SnO<sub>2</sub>-TiO<sub>2</sub>Ceramics

Stress Required to Densify a Low‐Fire NiCuZn Ferrite under Constrained Sintering

Processing and Properties of a Low-Fire, High-K Dielectric in H 2 /N 2

Low‐Fire Processing of Microwave BNBT‐Based High‐k Dielectric with Li2O–ZnO–B2O3 Glass

Low-Temperature Sintering Behavior and Mechanical Properties of Bn-Zro2-Sic Composites

The Effect of Applied Stress on the Densification of a Low‐Temperature Cofired Ceramic‐Filled Glass System under Constrained Sintering

Low Temperature Sintering of Zn1.8sio3.8 Dielectric Ceramics Containing 3Zno-2B(2)o(3) Glass

Influence of bismuth oxide as a sintering aid on the densification of cold sintering of zirconia

Structures and Dielectric Properties of Pyrochlore Bismuth Zinc Niobate Thin Films with Zinc Compensation

Electrical Properties Of Low-Fire Ferroelectric Plus Ferrimagnetic Ceramic Composite

Pressureless Sintering of Zirconium Diboride Ceramics with Boron Additive

Mechanical Properties and In-Situ Toughening Mechanism of Pressurelessly Densified ZrB2–TiB2 Ceramic Composites

A New Sintering Approach to Ceramics at Low Temperature from Ba(Zr X Ti 1- X )O 3 Nanoparticles Doped by ZnO

Pressureless sintering and properties of additively manufactured ZrB2–SiC

Densification mechanism, microstructure and mechanical properties of ZrC ceramics prepared by high-pressure spark plasma sintering

Dielectric Properties of 0.85Pb(zn⅓nb⅔)o3-0.15Batio3-mgf2·srf2ceramics